Joerns Healthcare Hoyer 4-Point Adaptive Positioning Powered Cradle

Joerns Hoyer 4-Point Powered Cradle is Compatible with:

• Joerns Hoyer Stature Professional Patient Lift

How to Use Hoyer 4-Point Adaptive Powered cradle?

• Removal
  - To attach your 4-point Adaptive Power Cradle, you must first remove the old spreader bar/cradle from the lift
  - This is achieved by removing the quick-release pin that retains the non-powered spreader bar/cradle
  - A small flat-blade screwdriver or similar is the only tool required
• Connection
  - To connect, raise the 4-point Adaptive Power Cradle towards the boom slot
  - Insert the pin sleeve through the lift boom, the black plastic end cap, and the cradle kingpin
  -  Once the pin sleeve has been installed and is supporting the weight of the Adaptive Power Cradle, re-insert the quick-release pin fully into the sleeve until it locks into position
  - To verify that the pin is securely fitted, press your finger into the barbed end. If the pin remains stationary, the lift is safe to use

Safety Precautions:

• Attach clip to lug
• Pull the plastic clip down to secure
• Feed the green ‘safe’ tab through
• Sling is attached and ready to use

Caution:

• Before removing the quick-release pin, the cradle must be supported by a stationary object such as a workbench or table
• This will prevent the cradle from dropping suddenly, which could result in an injury or damage to the cradle. 

Joerns Hoyer 4-Point Adaptive Powered Cradle Instruction Manual