Graham Field Lumex Fast Alert Basic Patient Alarm with Bed Pad

Graham Field Basic Patient Alarm Features

• Delay function allows for 0 or 2 second delay to reduce likelihood of false alarms with restless users
• Comes with protective boot cover to prevent damage if dropped 
• Off switch and Low battery indicator 
• Alarm easily secures with self contained clip onto areas such as wheelchairs
• Graham Field Lumex Fast Alert Patient Alarm with Bed Pad User Manual

How To Use Lumex Fast Alert Alarm?

Alarm Set Up:

• Remove the screw that holds the battery compartment cover in place 
• Inside the battery compartment 
• Set the delay switch to either 0 or 2 seconds. Selecting 2-second alarm delay may reduce the likelihood of false alarms when used with restless patients - 
• Install a new 9V alkaline battery (not included) 
• Replace battery compartment cover and reinstall screw

Alarm Testing:

• Insert the sensor pads telephone-style plug into the monitors sensor mat jack until it clicks into place
• To protect the cable plug end from accidental pull force, route the cable through the strain relief 
• Set the HI/LO/OFF switch located on the side of the monitor to the HI or LO position depending on desired alarm volume
• Use your hand to apply pressure to the sensor pad. The monitor will automatically sense the pressure and beep when activated
• Remove the pressure and the alarm will sound. To silence the alarm, set the HI/LO/OFF switch to the OFF position

Maintenance :
Warning: - Test the alarm before each use

• If alarm fails to sound, remove it from service immediately
• Check before each use that all alarm components are functional and battery is charged 
• The Low Battery indicator on the front of the alarm will flash when battery is low and needs to be replaced 
• Replace battery immediately if indicator flashes

Cleaning: - Gently wipe alarm components with a soft, clean cloth

Caution:

• Do not use cleansers that could damage the alarms finish 
• Do not submerge any alarm components in liquid.