Drive Check And GO Oxygen Analyzer With Three Digit LCD Display

Features

• LCD Display:
  - A 3-digit display provides a direct readout of oxygen concentration in the range of 0 - 99.9%. The display is blank when the Check and Go enters its Sleep (power off) mode. The Check and Go will automatically enter the Sleep mode after approximately 1.3 minutes from the last time the ON button was pressed
• ON/OFF Button:
  - Use this button to turn the Check and Go on and off. When the Check and Go is in the Sleep (power off) mode, the LCD display is blank. The analyzer turns off after 1.3 minutes if no buttons are pressed
• Calibration Button:
  - Press the calibration (CAL) button to adjust the calibration value to reflect the known oxygen concentration. To simplify operation, the Check and Go automatically determines the calibration gas being used as compressed air (20.9%) or high grade (100%)
• Flow Diverter:
  - The flow diverter is designed to fit industry standard 15 mm I.D. "T" adapters
• Ultra light weight and stable
• Maintenance free
• Click Here For Operating Manual

More Information

• Cleaning and Maintenance:
  - When cleaning or disinfecting the Check and Go Disposable, take appropriate care to prevent any solution from entering the analyzer
  - The Check and Go Disposable surface may be cleaned using a mild detergent and moist clothe
  - The Check and Go Disposable may be disinfected using standard topical disinfectants
  - The Check and Go Disposable is not intended for steam, ethylene oxide or radiation sterilization
  - Store the Check and Go Disposable in a temperature similar to its ambient environment of daily use

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov