Ottobock CTO Cervical Thoracic Orthosis

Ottobock CTO Cervical Thoracic Orthosis Features

• Unique quick adjusting straps and stops ensures the device is reapplied the same every time
• Step down system provides support throughout patient recovery
• Two piece design increases air flow, comfort and ease of application
• Additional foam pad set included for patient hygiene
• Indications:
  For use following injury or operative procedures where non-invasive restriction and immobilization of the cervical and upper thoracic spine is desired
  - Light wedge fractures following traction or occipital avulsion fracture
  - Jeffersons fracture without transverse ligament injury
  - Post trauma
  - Spinal Stenosis
• Note: Additional liners can be ordered separately

More On Cybertech Cervical Thoracic Orthosis

Application Instructions:

• Locate the handle on the left side of the device and fasten the handle near the pulley unit.
• While standing in an upright position, hold the side panels apart, and center the back panel of the device along the spine just above the tailbone.
• Wrap the left side panel to the front to position the front panel. Then wrap the right side panel on top of the left side panel to close. Attach both sides in front.
• Pull the handle out and away from the pulley unit to reach desired compression and support. Place the handle on the fabric fastener band securely.
   

Cleaning and Care:

• Remove the rigid components. The rigid components can be wiped clean with a damp cloth.
• Softgoods can be hand washed in warm water (90°F - 110°F or 32°C - 43°C) with mild detergent.
• Triple rinse, squeeze and air dry.
• Avoid twisting the material to remove water.