SleepSafe II Medium Bed - Twin Size

More On SleepSafe II Medium Bed

• Bed Size Selection:
  Following durable medical equipment (DME) bed sizes are available for SleepSafe Beds. Mattresses support up to 350 lbs. All size beds are available with all available foundations.
  - Twin Size: Offers a standard twin bed size. Mattress size is 38" by 77".
  
• Choosing Foundation Type:
  Every durable medical equipment (DME) SleepSafe Bed includes a foundation that supports the mattress. The following foundations are available for SleepSafe Safety Beds:
  - Fixed Foundation: Offers a foundation with a fixed height. The mattress will lie flat on a box spring or bunkie board. The height/positioning choice you make when installing the fixed foundation will determine the height of safety rail protection above the mattress.
  Example, if you choose to install at the lower position, this will increase the height of protection above the mattress. You may change the height of your fixed foundation at any time.
  Note: You have a choice when choosing the Fixed foundation of a box spring or bunkie board. There is no cost or comfort difference between the two options. The only difference in the two is the depth of each. A bunkie board offers approximately 5" more of safety rail protection.
  - Manual Foundation: Offers four choices. The hand cranks use a hydraulic system and are easy to use with little effort by the operating caregiver. The hand crank handles fold up into the shaft of the handle.
  
  • Manual Flat: Manual crank mattress height adjustment only. This will raise and lower the mattress height with one crank located in the front panel of the bed below the safety rail.
  • Manual Plus: Manual crank head and knee adjustment. This will raise and lower the head and/or knee section of the bed with a combination of two cranks located in the front panel of the bed below the safety rail.
  • Manual Electric:  Manual crank mattress height adjustment and electric head and knee adjustment. This will allow the user to raise and lower the head and/or knee section of the bed electrically with a remote. The raising and lowering of the mattress are controlled by a manual crank located in the front of the bed.
  • Manual HiLo: Manual crank head, knee and mattress height adjustment. This will raise and lower the mattress height and raise and lower the head and knee section of the bed with a combination of three cranks located in the front panel of the bed below the safety rail. With a hydraulic system, the hand cranks are easy to use with minimal effort by the caregiver.
  - Plus Foundation: Electric head and knee adjustment. Offers an electric frame with a fixed height. This foundation features head and knee elevation with remote control. With the touch of a button, you can elevate the head and/or knee section of the bed.
  As in the Fixed foundation, there are more than one height positions to choose at time of installation. The height/positioning choice you make when installing this foundation will determine the height of safety rail protection above the mattress. Example, if you choose to install at the lower position, this will increase the height of protection above the mattress. You may change the height of your fixed foundation at any time.
  - HiLo Foundation:  Electric head, knee and mattress height adjustment. Offers a Hi-Lo electric frame as your foundation with full articulation. Not only does the head and knee section elevate, but the Hi-Lo feature allows the mattress surface to be raised or lowered by remote control. This is considered a fully electric bed.
  Depending on where you position the mattress within the frame will determine the amount of safety rail protection above the mattress. When lowered all the way down you will maximize the rail height above the mattress. As you begin to raise the mattress from the floor, you will decrease that safety rail height above the mattress. With the Hi-Lo foundation, you can position the mattress anywhere within the range of motion of the frame.
  Important Note: The Hi-Lo electric foundation has a wired remote control on a cord plugged into the bed and does not operate more than one bed. No problem to have multiple beds in one space.
• Color Choices to Best Complement Your Room:
  The following wood choices are available for all SleepSafe Beds. SleepSafe beds are made of natural wood with a clear finish. Stain or paint are not used, allowing the natural beauty of the wood to shine through a protective clear finish.
  - Alder: It is a rustic birch with random knots and straight grain. It is moderately light with a clear, natural finish.
  - Maple: It is the lightest of wood choices and shows very little wood grain.
  - Oak: It is a bit darker than the maple, but relatively light in color and shows more natural wood grain.
  - Cherry: It is slightly darker than Maple and Oak but again, is still relatively light in color. Many people tend to think of the dark cherry stain when thinking of cherry, but remember this is the natural wood with no stain finish, however, over time, cherry wood will darken naturally over the years.
  - Mahogany: It should be the darkest of the wood choices but mahogany finishes will vary significantly. African Mahogany is used which is naturally lighter than typical dark Mahogany. The color will darken with time. Wood is clear coated to bring out the beautiful grain of wood.
  - Solid Color: It includes solid White, Blue, Green, Red, Yellow, Orange, Pink, Purple and Black. All leg posts are available in Maple only.
• Add-Ons To Comfort:
  - Padding: When ordering your bed, you will need to order your SleepSafe Bed with or without padding depending on your needs. Custom-fit padding provides protection from contact with the bed frame. The 3/4" high-density foam is covered with easy to clean waterproof nylon. It is important to make this determination when you order your bed as retrofitting your bed in the future will be costly. The cream color is standard.
  If you order padding, it will be installed at the factory and will cover all four sides. If you order padding with your bed, it is very important to never use the bed if you have removed one or more of the pads. If you remove any of the pads, a gap will be created between the mattress and the sides of the bed potentially creating a risk for entrapment.
  - IV Pole: It can be installed anywhere on the footboard or headboard. It is a 30-inch stainless steel pole with 2 ram hooks.
  - Headboard Window: It is available for installation in the headboard.
  - Footboard Window: It is available for installation in the footboard.

Specification

Customer Reviews

Questions & Answers

Ask a Question

Enter your question below:

 

Security question 3+ 7 =   SubmitCancel

Enter your Answer below.

Security Question:3 + 7 =

	ItemQuestion ItemName - now
	Your question will show here once it will get approved.

	UserAnswer UserName - now Your Answer will show here once it will get approved.