ROHO High Profile Single Compartment Cushion

How to use ROHO High Profile Cushion?

• Have a history of skin/soft tissue breakdown and/or any stage pressure injury (including deep tissue injury), skin grafts, and/or myocutananeous flap surgery
• Currently have skin/soft tissue breakdown and/or any stage pressure injury (including deep tissue injury)
• May be at risk for skin/soft tissue breakdown and/or deep tissue injury
• Have normal or impaired sensation
• Require accommodation of pelvic asymmetry, up to approximately 3in/7.5cm

1. Place the cushion in the wheelchair with the air cells facing up and the non-skid surface of the cover facing down. Consult your prescriber about alternate positions of inflation valves.
2. Slide the rubber nozzle of the hand pump over the inflation valve. Pinch the nozzle, turn to open the inflation valve, and inflate the air cells.
3. When all of the air cells are inflated and the cushion begins to arch slightly, pinch the rubber nozzle of the hand pump and turn to close the inflation valve completely.
4. Remove the hand pump.
5. Repeat cushion inflation for all valves.

How To Adjust Your ROHO Cushion?

		1. Place cushion on chair, making sure it is centered with air cells up, with air valve in front, left corner (when the user is seated). Turn valve counterclockwise to open.
		2. Slide the rubber nozzle of pump over the valve and inflate the cushion until it begins to slightly arch upward.
		3. Pinch the pump nozzle and turn valve clockwise to close. Remove pump. (Repeat steps 1 - 3 for remaining air valves on multi-valve cushions.)
		4. Have the user sit in the chair, making sure the cushion is centered underneath. The user should be seated in their normal sitting position.
		5. Slide your hand between the cushion surface and the user bottom. Lift their leg slightly and feel for their lowest bony prominence. Then lower their leg to a sitting position.
		6. Turn valve counterclockwise to let out air, while keeping your hand under the lowest bony prominence of person. Release air until you can barely move your finger tips – no more than 1 inch (2.5 cm) and no less than 1/2 inch (1.5 cm). Turn valve clockwise to close.

• To Clean the Cover: Remove the cover. Machine wash in cold water (30 degrees C) with mild detergent, gentle cycle, or wipe clean with neutral detergent and warm water. Tumble dry low.
• To Clean the Cushion: Remove the cover, close valve(s) and place in a large sink. Hand wash, using mild liquid hand soap, hand dishwashing liquid, laundry detergent, or a multipurpose detergent. Gently scrub all cushion surfaces, using a soft plastic bristle brush, a sponge or a cloth. Rinse with clean water. Air dry. Do not expose to direct sunlight.

ROHO Wheelchair Cushion Specifications

Warranty

ROHO Cushions Reviews