Homecraft Padded Transfer Bench

How to assemble Homecraft Transfer Bath Bench?

• Place top of transfer bench on an even surface. Determine the side of bench that will go into the bathtub, and on that side attach the legs that have large suction cups on the bottom. Use the push pins, depressing them and slipping leg into the frame connector on the bottom side of the bench. Follow the same steps to attach the other suction-cupped leg. On the opposite side of bench, attach the legs that have small rubber tips. Depress push pins and insert one leg at a time into each of the corresponding receptacles. Make sure the legs are secure before turning over the bench.
• The armrest should be attached on the same side of large suction-cup legs. Hold the armrest so that it curves away from the bench, and then connect it to bench by depressing the push pins, inserting the arm and releasing the pins.
• Before attaching the backrest to the bench, assemble it using the push-pin method. Push the pins and slip the poles into the backrest poles. Depress the push pins again to slide the poles of backrest into the holders underneath the seat. To ensure security the backrest must go through both holders. Reverse the back to change entry from right to left or vice versa. Position large suction-cup legs in the bath tub and adjust for individual user. To remove or reposition the legs, pull the tab on the suction cups. Check that the bench is level to be on the safe side.

Homecarft Padded Transfer Bench User Manual

Care: Use a mild cleaning product no abrasive, scouring pads or solvents including lacquer thinner, turpentine or acetone.

Precautions: Do not exceed the user weight capacity of 300 lbs. Test for stability before use.
 

Customer Reviews