3M Coban Non-Sterile Self-Adherent Wrap

More Information

• Suggested Applications:
  - Overwrap for splints, support sprains and strains
  - Secure dressings and devices
  - Compression to reduce edema
  - Reduce post-operative swelling
  
  
• Directions for Use:
  - Unwind approximately 12 inches of Coban self-adherent wrap from the roll and allow the wrap to relax
  - Without stretching, apply one full wrap and overlap. Press overlapped area lightly to keep the end in place.
  - Proceed with wrapping, applying tension to the wrap only to obtain desired compression
  - Always unwind more Coban self-adherent wrap from the roll before making a wrap so that the product is not applied with too much tension
  - When application is complete, cut off excess Coban self-adherent wrap
  - Secure the end of the application by gently pressing
  
  
• Warnings:
  - Coban self-adherent wrap will not slip or loosen after application
  - DO NOT wrap too tightly to avoid impairing circulation and causing serious injury
  - The risk of impaired circulation is higher for children
  - Monitor area frequently (no less than every 24 hours) for signs of swelling, discoloration, pain, numbness, tingling, or other changes in sensation
  - If these symptoms occur, remove wrap immediately and contact your health care provider
  - DO NOT place Coban self-adherent wrap in direct contact with an open wound because it may lead to infection
  
  
• Caution:
  - This product contains natural rubber latex which may cause allergic reactions
  
  
• Precautions:
  - When used as a component in a compression wrap system, it is important to ensure adequate arterial blood flow to avoid injury secondary to decreased circulation
  - Coban self-adherent wrap should be used as a component of a compression wrap system only under the supervision of a wound care specialist
  - Do Not Reuse, reuse may result in compromising product integrity and / or lead to device failure

Customer Reviews

Questions & Answers

Ask a Question

Enter your question below:

 

Security question 7+ 1 =   SubmitCancel

Enter your Answer below.

Security Question:7 + 1 =

	ItemQuestion ItemName - now
	Your question will show here once it will get approved.

	UserAnswer UserName - now Your Answer will show here once it will get approved.