Sigma Spectrum Infusion Pump

Features of Baxter Sigma Spectrum IV Pump

• Easy and fast priming of the Standard IV administration sets
• Bright high-contrast liquid crystal display
• Small and lightweight profile that enhances patient mobility
• Bi-directional wireless communication
• HL7 and XML communications

What to buy with Smart IV Pump

• McKesson Infusion Pump Pouch
• Covidien Kendall Monoject Purple Oral Dispenser Syringe
• Smith & Nephew IV Prep Antiseptic Wipes

How to set up and operate Smart IV Pump?

Keys

• Soft keys (the top row of keys on the keypad) are non-labeled keys with various functions depending on what is displayed above them.
• Arrows advance cursors and select alternate choices.
• Help selects photo instructions for things such as door opening / set loading.
• OK confirms entries and advances cursors.
• Setup starts programming.
• Letters are selected by pushing corresponding numerical keys once, twice or three times quickly.
• Basic allows selection of ml/hr setup (bypassing the drug error prevention system). Dose rate and ramp/taper modes may also be selected from basic.
• Clear erases the highlighted entry.
• CLR all erases the entire pump set up screen.
• Silence quiets the audio alarm for 2 minutes. Additionally, any key can be pushedfor silence.
• Hold places the pump in standby mode.
• On/off turns the pump on or off.
• Run/stop starts and stops the infusion.
• Options allow the user to select additional pump features.
• Back allows the user to go back.
• Reset resets manual programming mode to step 1.
• Ramp allows access to the manual programming mode.
• CLR step clears one step of manual programming mode.
• Titrate allows flow rate changes without stopping the pump.
• Bolus allows bolus setup without stopping the pump.
• Review pulls up the set up screen without stopping the pump.

Pre-pump programming

• Mount the pump to an iv pole.
• Plug the pump into a wall outlet if available.
• IV sets: select only iv sets made by the manufacturer listed on top of the pump. Iv Sets must be of standard stiffness and diameter. Performance can not be achieved Using stiff, large or small diameter tubing. Contact sigma for compatible standard iv Set lists and for special sigma blood, nitroglycerin and lipid sets.
• Pumped-on tubing should not be re-loaded into the pumping channel (to avoid Nuisance alarms and to maintain flow rate accuracy). Note: flow rate accuracy Will be maintained if the set has been pumped on for no more than 72 hours for Hospira and 96 hours for baxter iv sets at rate settings not greater than 125 Ml/hr, or for total volumes of not more than 9 liters (hospira) or 12 liters (baxter).
• Prepare IV containers and prime iv sets by positioning roller clamps Below the pump, positioning slide clamp near the keyhole at the top of the pump, Inverting bags that need to be mixed (rather than shaking them), warming iv Solutions to room temperature before use, filling drip chambers approximately Halfway and using standard gravity iv set priming technique to purge air from sets And all y sites.

Baxter Infusion Pumps User Manual

How to clean Baxter IV Pumps?

• To clean the pump, turn it off and unplug the AC power adaptor from the power source.
• Place the pump upright (keyhole release upward).
• Apply the compatible cleaning agent with a dampened cloth per the manufacturers’ instructions using the appropriate dilution ratio.
• Disinfectants should remain on the pump’s surface in an even but not dripping film for the compatible cleaning agents’ recommended contact time.
• Open the pump’s door using a standard IV set’s slide clamp.
• Clean the speaker vent, power adaptor connector, door release, Keyhole, and pumping channel areas with soft swabs.
• Apply solutions sparingly to the swabs and wipe down the necessary areas.
• Do not use rigid cleaning instruments or spray solutions directly on the pump.
• For severe solution spills, it is recommended that the Standard Battery/ Wireless The battery Module is removed.
• The Battery Pack cavity area of the pump may be cleaned by wiping down those regions with a dampened cloth, as described previously.
• Dispose of all cleaning materials (including the slide clamp) as required per facility protocol/biohazard policy.