Salter 8900 Series Disposable Small Volume Jet Nebulizer With Supply Tube

More On Salter Jet Nebulizer

• Firstly you need to assemble hand-held nebulizer that holds the medication during treatment and turns it into a fine mist, T-adapter, plastic mouthpiece through which the medication mist is delivered, 6-inch corrugated tube and 7-foot long air supply tube.
• Pick up the hand held nebulizer with one hand grasping the clear bottom section of the unit.
• With your other hand grasp the top opaque part of the nebulizer and rotate the top in a counter-clockwise direction.
• The top will disengage from the bottom. Set the top aside.
• Make sure that the green funnel-shaped cone is securely in place in the bottom of the nebulizer unit with the small end of the cone facing up.
• Hold the bottom of the nebulizer in one hand. With your other hand add your medication as directed by your healthcare provider into the cup along the side of the green cone.
• Try to add the medication along the side of the cup to prevent it from going down the hole in the green cone.
• Now replace the top of the nebulizer to the medication cup and then rotate the top in a counter-clockwise direction. The top will engage the medication cup.
• If you are planning to use a mouthpiece to take your aerosol treatment first attach the T adapter to the nebulizer by inserting the outlet on the top of the nebulizer to the inlet port on the T-adapter. This is the opening with three plastic rings.
• Now slide the T adapter firmly onto the nebulizer.
• Connect one end of a six-inch corrugated tube over the smaller diameter end of the T-Adapter.
• This tube stores excess aerosolized medication between inhalations to minimize medication waste and to improve the effectiveness of your treatments.
• Place the round end of the mouthpiece into the other end of the T adapter.

• Pediatric and Adult Aerosol Masks attach in the place of a mouthpiece, T adapter and corrugated tube to the handheld nebulizer.
• If you will be using either an adult or pediatric aerosol mask for your treatment assemble your nebulizer and connect it to the compressor as previously discussed.
• Connect the mask to the nebulizer by sliding the inlet port on the mask into the outlet on the top of the nebulizer.
• Your nebulizer mask assembly is now ready for use.
• Simply turn on your compressor. After a few moments, your compressor and nebulizer will be delivering a fine mist which you will inhale to get the medication deeply into your lungs.
• When using a mask for treatments you can hold it up to your face with one hand placing it securely over your nose and mouth and inhale deeply.
• Hold your breath for several seconds and exhale slowly.
• Continue this until there is no liquid remaining in the medication cup.
• Salter Aerosol Masks have a strap which you can place over and behind your head to hold the mask and nebulizer in place during your treatment.

• Salter Nebulizer must be cleaned between treatments.
• To do so, disassemble all the parts.
• Do not wash or rinse the supply tubing.
• After taking your nebulizer apart, wash all of the parts in warm soapy water.
• Rinse the parts in clean water and ensure that all soap residue is removed.
• Air-dry the parts on a paper towel.

Salter Jet Nebulizer Specifications

Customer Reviews

Questions & Answers

Ask a Question

Enter your question below:

 

Security question 7+ 4 =   SubmitCancel

Enter your Answer below.

Security Question:7 + 4 =

	ItemQuestion ItemName - now
	Your question will show here once it will get approved.

	UserAnswer UserName - now Your Answer will show here once it will get approved.

How does it ensure minimized wastage? Roger - 3/10/2017 2:42:50 AM

ReplyShare

	Larger surface area provided by unique convex cone design of Salter Small Volume Jet Nebulizer maximizes dispersion and minimizes medication waste. Maximum capillary action also eliminates medication waste. Customer Care - 3/10/2017 11:16:00 PM

How much time does it take for medication? Parag - 3/10/2017 2:42:08 AM

ReplyShare

	Salter 8900 Series Disposable Nebulizer nebulizes 3cc within 7 minutes or less at 7 LPM when held in a horizontal or vertical position and takes less than 10 minutes when held at an angle. Customer Care - 3/10/2017 11:15:42 PM

how many times can this nebulizer be used before disposing Bruce High - 11/14/2016 3:54:40 PM

ReplyShare

	Use a separate, clean Salter 8900 Series Disposable Small Volume Jet Nebulizer for each medication. Customer Care - 11/23/2016 6:33:34 AM

HOW DO I SET UP THIS NEBULIZER? CAROL BERGER - 12/30/2015 11:44:04 PM

ReplyShare

	Thank you for reaching out to us. The video in the product will help you resolve your query. Salter 8900 Series. Hope that helps. Customer Care - 12/31/2015 7:14:32 AM