Roscoe Rite-Neb 4 Nebulizer Compressor System

Roscoe Medical Nebulizer Compressor System Features

• Delivers better output for faster treatments and better patient compliance
• The compact design of the compressor nebulizer makes it portable
• Quiet at less than 65 dBA
• Compact and lightweight at 2.73 lbs
• Metal piston for durability
• Attractive retail packaging

Roscoe Rite-Neb 4 Nebulizer Compressor System User Manual

What does this Compressor Nebulizer Include?

• Compressor
• Nebulizer
• Tee
• Mouthpiece
• Reservoir tube
• Tubing
• Five extra filters

Roscoe Nebulizer Compressor Unit Parts

1. Compressor


2. Air Outlet


3. Power Switch


4. Power Cord


5. Air Filter

 

Roscoe Medical Nebulizer Accessories

1. Compressor


2. Air Outlet


3. Power Switch


4. Power Cord


5. Air Filter

 

What to buy with Roscoe Nebulizer

• Roscoe Medical Disposable Nebulizer Kit with Adult Mask
• AIRFREE IRIS 3000 Filterless Air Purifier
• Drive Check And GO Oxygen Analyzer With Three-Digit LCD Display

How to Operate this Compressor Nebulizer?

1. Take the power cord and plug it into an electrical outlet.
2. Check for moisture leakage near the nebulizer connections.
3. There are (3) ways to administer medication with this nebulizer
   
   • Hold the air intake near the nose (Figure 1).
   • If using a mask (optional), put the mask on the face (Figure 2).
   • If using a mouthpiece, hold it in or near the mouth (Figure 3).
4. Taking deep breaths in, inhale the liquid medication vapor.
5. When liquid medication is depleted, turn the power switch to “OFF”.
6. Unplug the power cord from the electrical outlet.
7. Detach the tubing and accessories from the compressor unit.
8. Clean and sterilize tubing and accessories

How to clean the Nebulizer Components and Accessories

1. Disconnect the tubing from the compressor and from the bottom of the nebulizer cup.
2. If there is any moisture (condensation) in the tubing, let the compressor run with the tubing only for 2 – 3 minutes. The warm air from the compressor will dry out the tubing. Alternatively, you can dry the tubing by removing it from the compressor and hanging it up with the “ends down” to allow the moisture or condensation to drain out and evaporate. Use a clean, damp cloth to wipe the exterior of the tubing.
3. Disassemble the tubing end of the accessories.
4. Wash all parts with warm water and liquid dish soap. CAUTION: DO NOT WASH THE TUBING.
5. Rinse thoroughly with warm water and shake out the water.
6. Air dry or hand dry nebulizer parts with a clean, lint-free cloth. Reassemble the nebulizer when the parts are dry and store them.
7. You can also wash the reusable nebulizer (optional accessory) on the top shelf of a dishwasher. Masks cannot be washed safely in a dishwasher. DO NOT WASH THE TUBING. Place the parts in a dishwasher basket and place the basket on the top rack of the dishwasher. Remove and dry parts when the cycle is complete.
8. With proper care, disposable nebulizer kits should be replaced every 2-4 weeks, and optional reusable nebulizer kits should be replaced every 6 months

How to clean the compressor?

1. Wipe daily with a damp cloth.
2. Do not use any powdered cleaners or soap pads, which may damage the finish.

How to change the Nebulizer Filter?

1. Do not use cotton or any other materials. Do not wash or clean the filter. Only use filters supplied by your distributor, and do not operate without a filter.
2. Change the filter every 15 – 30 days or when the filter turns gray
3. Changing procedure:
   • Remove the filter cover.
   • Replace the used filter with a new one.
   • Replace the filter cover.