HealthCraft Invisia Shampoo Shelf Features
- 4-point wall connection provides maximum structural support
- Exceeds ADA 4.26.3 structural strength requirements for grab bars and fasteners (250lbs)
- Discreet wall stems with concealed screw makes mounting areas virtually invisible
- Adds functional storage and a sturdy grab bar that supports up to 500lbs
- Durable, non-porous solid surface tray is removable for easy cleaning
- Solid surface tray is shatterproof and resists the growth of mold and bacteria
- Supports up to 500lbs (227kgs) when installing to structural wood backing
- Made from durable, rust, resistant stainless steel
- Solid construction and mounting
- Discreet wall support
- Suitable for use in a wet environment
- Instruction Manual
Installation Instructions for Invisia Shampoo Shelf
- Back off set screws from rail sockets
- Allow wall stems to freely move in and out of rail sockets
- Peel off label on back of wall stems to expose sticker
- With wall stems inside rail sockets, push the rail against the wall. Ensure level
- Firmly press the rail so stickers on back of wall stems contact wall
- Remove rail carefully so wall stems stay on the wall
- Using wall stems as locating guides, mark the tile with center punch
- Drill pilot holes for fasteners. Fasten the wall stems to the wall using appropriate fasteners and waterproofing
- Place rail back onto the fastened wall stems
- Secure rail to wall stems by tightening set screws
- Using wall plate as a locating guide, mark the tile with center punch and drill pilot holes for fasteners
- Secure rail to wall by lower holes
- Cover screw heads with plastic caps (x2). Inspect hardware regularly, and tighten if required
- Remove protective sheet on rubber bumper to expose adhesive, and place (adhesive facing upward) on spoke of rail
- Slide tray in from the side, center with rail and lower onto bumpers so the adhesive sticks to the bottom of the tray.
Specification
Particulars | Specification |
| Material | Stainless steel |
| Finish/Color | Polished Chrome (CP), Brushed Stainless (BS), Powder Coat Bronze (ORB) |
| Tray Material | Solid surface material |
| Weight Capacity | 500lbs / 227kgs (ADA Compliant) |
| Rail Diameter | 1.25" / 31.8mm (ADA Compliant) |
| Rail Length | 19.75" / 502mm |
| Rail Depth | 5.05" / 128mm |
| Rail Height | 5.25" /133mm |
| Installation Mechanism | Must screw to wood backing behind wall. Aligns with 16" stud spacing |
| Installation Hardware/Fasteners | 10 x 3"/76mm length, stainless steel wood screw (x2) and 10 x 2"/51mm length, stainless steel wood screw (x2) |
| Fasteners Exposed or Concealed | Concealed; rail stems cover mounting hardware and plastic caps (x2) |
| Commercial Use | Yes |
| Residential Use | Yes |
| Water Resistant | Yes |
| Rust Resistant | Yes |
Warranty
Limited lifetime warranty Products are covered by a limited lifetime warranty against defects in materials and workmanship for the original purchaser. Warranty excludes products that have been damaged through misuse, accidental damage, alteration, normal wear and tear, wood material and stain, or the use of corrosive or abrasive cleaning products.
