Drive Bariatric Battery Powered Patient Lift with Four Point Cradle

Drive Battery Powered Patient Lift With Four Point Cradle has an extra wide, coated cradle that rotates 360 degrees and includes 4-point hook up. A high lift range allows the unit to transfer patients to high surfaces. The battery can be charged by plugging in the unit, and never needs to be removed. A jumbo actuator pump that lowers the patient ensures safe repositioning. The pump even includes an emergency button and can be switched to manual mode.

Features

• Drive Bariatric Battery Powered Patient Lift with Four Point Cradle has 600-pound weight capacity
• Base legs adjust easily and lock securely into open position with padded shifter handle
• Dual, 3" heavy duty front casters
• Extra wide coated swivel bar with 360 degrees rotation with 4 points hook up
• High lift range allows transfer to high surfaces
• Ideal for homecare use
• Lift will not operate while plugged in
• To charge, simply plug in unit
• Click Here for
  - Troubleshooting
  - Casters Changing Instructions

More Information

• Instructions
  - It is designed to transfer a patient from one resting position to another. It is not a transport device. Use a sling that is recommended by the individual physician. During the transfer, with patient suspended in a sling to the lift, do not roll caster base over objects such as raised carpet bindings, door frames, or any uneven surfaces that would create an imbalance of the lift. Use steering handles at all times to maneuver the lift
• How to operate
  - Spread the base legs to the widest position before lifting
  - Keep the patient-centered between the base legs and have the patient face the attendant
  - Be extremely cautious and use restraint straps for spastic or severely handicapped patients
  How to use Standard or Commode Slings
  - For smooth and easy lifting, have the lift, chains, sling, commode or wheelchair in ready positionWith the patient in the center of the bed, roll patient on side away from the attendant
  - Roll the patient on the side toward the attendant and center the patient on the sling. With the base of lifter under the bed, press the down button on the control handset to lower the boom. on the control, handset to lower the boom
  - Hook the hanging strips of sling with the hanging bar. If a chain is used, make sure the "S" hooks are away from the patient. Lock rear casters, lift the patient by pressing the up button on the control handset
  - Lift patient until his/her feet will swing easily off the bed keeping patient facing the attendantUnlock rear casters and transfer patient to and above commode or wheelchair.
  - Lock brakes of both lifter and commode (or wheelchair)
  - Press the down button on control handset to gradually lower the patient
  - During the descent, assist patient to attain correct sitting posture
  - For transferring to the wheelchair, when the patient is seated, push down on the boom to slacken hanging strips of the sling. Patient can remain seated in sling
  - For commode use, adjust clothing before moving lift to straddle commode. Keep hanging strips taut and make sure patiently is in a comfortable position
• Important safety instructions:
- Patient lifter is a transfer device that allows patient attendant to transfer patients from bed to wheelchair or commode etc
- It should not be used to transport patients
- When lifting patient, make sure the base legs are in the most widely opened position and the rear caster brakes are engaged. This will prevent tipping
- When battery power goes below 50%, the controller has an audible warning. When the low battery warning is heard, charge the battery immediately. Please note that a lifted patient cannot be lowered down when battery is out of power
Push the red button if the control unit system is not functioning properly
- In the event of a power failure, a person can be lowered by pulling up on the red quick release lever
• How to charge
- Insert the power cord into the bottom of the control box and the other end into a wall outlet
- The battery is charging when the light is illuminated.
- When the battery charge is completed, the light will shut off automatically (on average, it takes approximately 4 hours to charge from 50% to 100% capacity)
- Remove the power supply cord
- The lift is now operational