Breg Vectra Basic Walker Boot

Breg Vectra Basic Walker Boot Features:

• Lightweight walker boot with a very low profile footbed height
• Dual-Axis rocker bottom encourages a more natural gait
• Breathable Airmesh liner with glass-filled nylon uprights and removable heel clip
• Wide footbed accommodates swelling and post-op bandages 
• Common Examples of Use:
• - Soft tissue injuries of the lower leg
  - Moderate to severe ankle sprains
  - Syndesmosis (high ankle) sprain
  - Forefoot/midfoot/hindfoot pain and injuries
  - Stable foot and/or ankle fractures
  - Post-ORIF and surgical stabilization after tendon/ligament repairs
  - Metatarsal fracture
  - Other acute or post-operative use (i.e. bunionectomy)
• Instruction Manual

More On Breg Vectra Basic Walker Boot

• Fitting Instructions:
  - Apply liner to leg 
• With patient seated, leg(s) bent and feet off floor, position tongue pad as needed for maximum comfort, close liner snugly
  - Slide walker onto leg over the liner straight up directly underfoot
  - Fasten straps
  Start with straps 1 and 2 closest to the toes (Straps may be trimmed to the desired length)
  - Position walker with uprights centered over the malleoli (ankle bones)
  Ensure heel is positioned at the rear of the Walker
  - Remove quick-pulls from the uprights and discard
  Attach uprights to the liner
  Press firmly
  - Fasten straps
  Affix straps 3 through 5 to the outside of the uprights by alternating the buckle placement
  Then fasten straps 3 through 5


• Use and Care:
• - After initial application, the Vectra may be removed and reapplied without removing liner from boot- Hand wash the liner and straps with mild soap, air dry
  - Do not place liner or straps into a mechanical dryer




 
•  
•