3B Medical Siesta Nasal CPAP Mask FitPack

Siesta Nasal CPAP Mask Features

• Easy grip cushion cup
• All size kit for a perfect fit
• New headgear design
• Modern mask technology
• Freedom of movement 

What Siesta Nasal CPAP Mask Fitpack Includes

• CPAP mask
• Headgear
• Cushion of small, medium and large sizes

What to buy with Siesta Nasal Mask

• 3B Medical CPAP Travel Wipes
• 3B Medical Lumin CPAP Mask And Accessory Cleaner
• Maril Control III Disinfectant CPAP Cleaning Solution

How to use 3B Mediacal CPAP Mask?

Fitting the Siesta CPAP Mask

1. Attach the headgear straps by threading them through the gaps of the forehead frame and clips.
2. Hold the mask over your nose and pull the headgear over your head. 
3. Bring the lower headgear straps below your ears, connect the clips to the frame assembly. 
4. Adjust the upper headgear straps evenly until they are comfortable and secure, and reattach the mask.
5. Adjust the lower headgear straps evenly until they are comfortable and secure, and reattach the mask.
6. Now mask is ready to be worn.

Disassembling the Siesta Mask

• Undo and remove the upper headgear straps out of the slots on the frame.
• Remove the cushion assembly from the frame assembly.
• Remove the short tube from the frame assembly.

Cleaning the 3B Medical Siesta CPAP Mask?

• The mask and headgear can only be cleaned through hand washing or placed in the lumin device.
• The headgear may be washed without removing the clips
• When washing the mask, the elbow and the frame cannot be disassembled from the frame assembly.
• Always follow cleaning instructions and do not use solutions containing bleach, chlorine, alcohol, aromatics, moisturizers, antibacterial agents, or scented oils to clean any part of the system or air tubing, otherwise may damage the mask.
• Exposing any part of the system or tubing to direct sunlight or heat may cause deterioration.
• If any visible deterioration of the component is apparent (cracking, crazing, tears etc) the component should be discarded and replaced.

How to care for Siesta CPAP Nasal Mask

• Disassemble the mask components according to the disassembly instructions.
• Thoroughly clean the separated mask components (excluding headgear), by gently rubbing in warm (approx. 30°C) water using mild liquid detergent (e.g., Alconox diluted at 1%) for up to 10 minutes.
• Use a soft bristle brush to clean the vent.
• Rinse all components well with drinking quality water and allow to air dry out of direct sunlight.
• When all components are dry, reassemble according to the reassembly instructions.

• Handwash the headgear and all components in warm (approx. 30° C) and mild liquid detergent (e.g., Alconox diluted 1%) for up to 10 minutes. Rinse the components well with quality drinking water and allow them to air dry out direct sunlight before assembling.