Thumb Hole Wrist Cock-Up Precut Splint

Features of Thumb Hole Cock Up Splint

• Places the wrist in a neutral position and minimizes deviation
• Thumb Hole Wrist Cock Up Splint provides comfortable, circumferential support to hold the wrist at the desired angle of flexion or extension
• It supports the wrist in the correct position and allows free finger motion
• It may decrease pain caused by carpal tunnel syndrome and other wrist disorders

What to buy with Thumb Hole Wrist Cock-Up Splint

• Quick Freeze Cold Spray
• Rolyan Replacement Strap Kits For Individual Splints
• Rolyan Elbow Pre-Cut Splint

How to use Thumb Hole Cock Up Wrist Splint?

1. Use scissors to cut the ThermoTubesu to the desired length. To shape or curve the ThermoTubest for an outrigger or finger splint, the entire piece can be heated in hot water at 140° to 160° F (60° to 71° C). Use soap in water to decrease tackiness, if needed. Mold into shape gently on the tabletop to avoid collapsing and cool.
2. For outriggers and line guides, apply solvent, if needed, and use a heat gun to heat the surface of the splint where the ThermoTubesu will be attached. Heat the surface until it becomes soft and tacky.
3. Use the heat gun to heat the Thermo-Tube, which will be attached to the splint. Keep the heat gun nozzle approximately 2" (5 cm) from the surface for about 15 seconds until it becomes tacky. You have approximately 15 seconds to position the ThermoTubeu before it loses its tackiness.
4. Place the ThemoTubeu onto the tacky splint surface. Note that the two bonds instantly when in contact.
5. Cut the outrigger line to the needed length and thread it through the ThermoTube.