Pain Management Soft-Touch Self-Adhesive Carbon Electrode Cloth Back With Tyco Gel

Why choose Soft-Touch Carbon Electrode (Tyco Gel)?

• Pain Management Soft-Touch Self-Adhesive Carbon Electrodes Foam Back With PMT Gel utilizes a foam backing that will not absorb sweat like a cloth electrode
• Ag silver conductor with great performance
• Ultra tight pigtail connector, and a snug plug
• Prewired and reusable electrode for electrotherapy
• Effective for use with TENS, EMS, Interferential, Microcurrent, and Galvanic Generators
• It has oval curves that minimize edge curls

What to buy with PMT Medical Self-Adhesive Electrodes

• BioMedical Tens Prep Wipes
• Pain Management Electrotherapy Electrolyte Spray
• BodyMed Ultrasound Gel

How to use PMT Self-Adhesive Electrodes?

How to apply PMT Carbon Electrode with Cloth Back?

• Be sure the stimulator is turned off.
• Insert the pins of the lead wire from the stimulator into electrode wire connectors.
• Remove the electrodes from the protective liner by lifting them at the edge of the electrodes and peeling them from the Liner. Keep the protective liner in a storage bag after removing it.
• Clean the skin thoroughly. Electrodes do not stick to the skin with Lotion, oil, make-up, or dirt. etc. Leave the skin moist before application.
• Apply the electrodes firmly to the skin. Adhesion improves if the skin is at room temperature.

How to remove PMT Cloth-Back Electrodes?

• Before removing the electrodes from the skin, turn the stimulator off.
• Lift the edge of the electrodes and peel them from the skin. Do not pull on the Lead wires as you may damage the electrodes.
• Place the electrodes on the liner and gently remove the lead wire by twisting and pulling at the same time.

Care Instructions for Pain Management Soft-Touch electrodes

• Electrode life span and effectiveness can be enhanced by rubbing a small drop of water on the pad after use.
• Always keep your pads in the airtight package directly after use.
• For the best therapy results, it is recommended that your Electrodes are replaced after the conductive gel starts to wear down.
• This occurs after 10-15 uses per pad, depending on the length of the use.