Optec SALO TLSO Back Support

Features of Optec SALO Custom TLSO Back Support

• Available in single opening and bivalve design
• Can be used for patients of the general population
• Best for pediatric, geriatric, and wheelchair-bound patients requiring spinal stabilization and support
• The plastic outer layer allows proper alignment of the spine
• The rigid foam middle layer adds stability
• Soft hypoallergenic foam of the inner layer provides the patient with excellent padding and overall comfort

Material Information

• Outer Layer: LDPE, MPE, or HDPE
• Middle Layer: Rigid foam
• Inner Layer: Soft hypoallergenic foam in 1/8”, 3/16” or 1/4”
• Degree of Lordosis: Custom fabricated lordosis
• Overlap Options: Smooth, step (butted), or with tongues
• Opening: Anterior or Bivalve

When to use this Product?

Optec Custom TLSO Back Support is indicated for:

• Cancer patients
• Cerebral palsy
• Spinal stabilization
• Myelomeningocele
• Muscular dystrophy
• Paraplegia
• SpondylolisthesisPostoperative
• ScoliosisDegenerative, Herniated or Bulging Disc
• Wheelchair seating support

What to buy with Lumbar Support Belt

• Core Standard Sitback Lumbar Support Cushion
• OPTP SI-LOC Sacroiliac Support Belt
• Point Relief ColdSpot Lotion Gel

How to wear this Custom TLSO Back Support?

1. Begin with the patient lying down. Carefully log-roll the patient onto his side and place the posterior portion of the SALO brace onto the patient’s back. Align the waistline groove just above the patient’s pelvic bone but below the rib cage. While holding the back shell in position, return the patient onto his back.

 

2. Once the patient is on his back, adjust the position of the waistline grooves of the posterior shell so that they are oriented just above the patient’s pelvis but below his ribs. Then place the anterior portion of the brace onto the patient's chest, aligning the waistline grooves with the posterior portion while ensuring that the undershirt is smooth underneath the brace. This prevents the patient's skin from being pinched.

 

3. Tighten the bottom Velcro strap on one side. Then tighten the bottom Velcro strap on the opposite side. Repeat this for each strap until you complete tightening with the top straps. While tightening the top Velcro straps, pull up in a diagonal direction on the undershirt. Again, this prevents the patient’s skin from being pinched.

 

4. When the straps have been tightened, there should be no gap between the anterior and posterior portions. For best results, re-tighten straps with the patient laying on a flat surface with knees bent and feet flat. Finally, ensure that the orthosis fit is snug and does not cause any discomfort.

 

Optec SALO TLSO Back Support Fitting Guide

Care Guidelines

• Before cleaning, remove plastic inserts from the front and back panels
• Hand wash at 86 F with mild soap
• When drying, do not expose to direct heat (heater or sunlight) air dry
• Never iron or dry clean
• If not rinsed well after washing, residual soap may cause skin irritation and product deterioration
• It is not uncommon for your body to change size under the spinal brace, because of the compression of the brace and because of a reduction in post-surgical swelling
• If you change enough in size that you can no longer adjust the straps enough to get good compression, see your practitioner for a follow-up visit to resize or replace your brace. Your practitioner knows your medical status and is using the spinal brace as one part of your total care. It is important to follow his or her instructions exactly, even if they differ from some of the following guidelines.