McKesson Ultra Pull On Adult Absorbent Underwear

How to apply Ultra Pull On Underwear while Standing?

Remaining Application Steps of Mckesson Ultra Pull Ons

1. Spread the front side panels against the hips toward the back of the body.
2. Then overlap the rear side panels on top of these toward the front of the body. Use the hook and loop tabs to secure the brief. The tape tabs always go on the front of the body. The bottom two tabs should be angled slightly upward. The top two tabs should point straight across, or be angled slightly downward.
3. Press down on the tabs to secure them to the outside.
4. Smooth out all wrinkles and folds and check the fit of the product. Make any adjustments as necessary. Remember, the closure tabs can be unfastened and fastened again if needed.
5. Gently pull the skin of each inner thigh downward and away from the perineal area. This allows the leg cuffs inside the brief to move into place.

How to measure for McKesson Ultra Pull On Underwear?

To maintain the proper fit and level of absorbency selecting the proper size Absorbent Adult Pull Ups Underwear is important. The appropriate size can be determined by either using a measuring tape or using the height and weight of the user.

To measure using the Measuring Tape:
Measure the patient from hip to hip and multiply by 2 and add 2 inches. Once you have the total hip measurement, use the McKesson sizing chart and determine the proper size based on the product.

To measure using the Height and Weight of the user:
Refer to the McKesson sizing chart. For example, if the patient is 5'5" and 140 pounds then you would select a size Medium. See sizing chart above.

Compare Your Absorbent Underwear