Hollister InView Extra Male External Catheter

More Information

• Use the Hollister sizing guide to determine correct size needed
• Place the Hollister sizing guide over the widest diameter of the penis 
• In cases of shorter shaft length, select the InView Special catheter for better adhesion

• Clean and thoroughly dry the penis. Do not use lotions, powders or ointments on the skin. Trim hair as needed
• Be sure to have good visualization and access to the area
• Unroll the catheter onto the penis
• Gently squeeze the applied catheter to ensure good contact between the adhesive and the skin
• Connect to a bedside collector or a leg bag
• Secure the tubing leading to either a leg bag or gravity drainage bag to the individuals thigh to prevent unnecessary tugging on the catheter
• Position the tubing for the leg bag or gravity drainage bag below the level of the bladder

• Gently roll the catheter off the skin
• Use of a warm, wet washcloth, held over the catheter for approximately 30 seconds may help weaken the adhesive for easier removal in some cases
• Adhesive remover wipes may also be helpful

Specification

Customer Reviews

Questions & Answers

Ask a Question

Enter your question below:

 

Security question 3+ 6 =   SubmitCancel

Enter your Answer below.

Security Question:3 + 6 =

	ItemQuestion ItemName - now
	Your question will show here once it will get approved.

	UserAnswer UserName - now Your Answer will show here once it will get approved.

How do you measure,  for the external catheter,  diameter or circumference? Rod - 3/20/2015 6:40:49 PM

ReplyShare

	You can measure the circumference (c) of the penis in millimeters and use the following formula to determine your size: (c x 7)/22. This formula will give you the diameter of the penis, which is how external catheters are measured (e.g., 25 mm, 29 mm, et cetera). Customer Care - 3/21/2015 12:30:43 AM