HealthCraft SuperPole System

Reasons to Buy SP-S Transfer Pole

• Installs in minutes via tension between floor and ceiling, easy to relocate or remove with no damage to ceiling
• As mobility needs change, accessories can be added onto the SuperPole to offer more advanced support
• Versatile and installs anywhere in floor and ceiling, placing transfer support directly where it is needed
• Comfort foam hand grip provides a comfortable gripping surface
• Non-marking base plate rubber, ribbed for better gripping
• Grip material is in Grey with premium high quality grip
• Stylish clean and modern design will suit any decor
• Prevent marring of floor and stipple ceilings
• Use it on beside a bed, bath, toilet or chair
• Useful for those with limited hand strength
• Non-slip, PVC closed foam grip material
• Anti-microbial white powder coat finish
• SuperPole supports up to 300 lbs
• Latex-free

What to Buy with HealthCraft SP-S SuperPole?

• HealthCraft SuperBar Add-On Kit
• HealthCraft Uni-Fit Height Extender for SuperPole
• Also Available (Separately):
  HealthCraft SuperPole FRS Assist Pole
  HealthCraft SuperPole FRS Floor Receptacle Only

How to Install SuperPole System?

• On a flat horizontal surface, place top plate onto pole.
• Align holes and install clevis pin with washer on opposite side.
• Install cotter pin into clevis pin.
• Place base plate on floor at intended location, and tilt pole.
• When upright, install the pole into the base plate hole.
• Insert shaft of screwdriver thru drive hole of extension screw.
• Hold pole and turn screwdriver clockwise to raise pole.
• Top plate must contact ceiling squarely.
• Continue turning extension screw approx 2-5 turns until pole is secure.
• Turn jam nut until it is tight against bottom of pole.
• Turn both jam nut and extension screw together to jam tight.
• Remove screwdriver and lower cover sleeve to conceal screw.
• SuperPole System User Manual

Note:

• This System should only be installed between floors and ceilings of solid construction or injury may result.
• This System should not be installed on loose floor coverings, in rooms with radiant ceiling heating, in mobile homes, or in suspended or angled ceilings.