ConvaTec SUR-FIT Natura Two Piece Pre-Cut Stomahesive Skin Barrier With Tape Collar

SurFit Natura Skin Barrier Features

• Holds securely to skin while helping to protect against irritating output
• Coupling ring provides audible click confirming secure connection to skin barrier
• Two-piece design permits easy ostomy pouch removal for venting or changing
• Maintains adhesion to the skin when showering, bathing and swimming

What to buy with Convatec Skin Barrier

• ConvaTec AllKare Adhesive Remover Wipe
• ConvaTec SUR-FIT Loop Ostomy Rod
• Tytex CareFix StomaSafe Plus Ostomy Support Garments

How to use ConvaTec SUR-FIT Skin Barrier?

Begin by cleansing the peristomal skin with mild soap and water (soaps should be free of oils and creams). Pat dry thoroughly. The skin should be free of any solvent or greasy substances.

ConvaTec SUR-FIT Natura Skin Barrier/Wafer Preparation

• Measure the stoma size with the measuring guide provided. Select a skin barrier/wafer with a flange (white ring) that is at least 1/2" (13mm) larger than the widest diameter of the stoma. If this size is not available, go to the next larger flange size.
• Trace the exact stoma size onto the center white release paper in the back of the skin barrier/wafer. The small starter hole should be in the center of your tracing.
• Cut along the tracing with curved, short-blade scissors. For skin barriers/wafers with precut stoma opening: Select a skin barrier/wafer with a precut stoma opening the same size as the largest diameter of the stoma. Do not enlarge the precut stoma opening. Remove the white release paper from the skin barrier/wafer. Leave the outer release paper on the tape collar in place.
• Stomahesive Paste can be applied to the back of the skin barrier/wafer to further fill gaps between the skin barrier/wafer and the stoma. Allow the paste to set for one minute prior to application to the skin. (Do not spread the paste.)

How to apply Convatec Sur Fit Natura Stomahesive Flexible Skin Barrier?

• Center the skin barrier over the stoma. Press the skin barrier against the skin. If using a tape bordered skin barrier, remove the remaining backing paper one side at a time.
• During application, maintain gentle pressure on the skin barrier for 30 seconds to improve adhesion.

How to remove ConvaTec Stomahesive Wafer?

• Gently pull the skin barrier down, away from the skin, while supporting the adjacent skin with your other hand
• To assist with the barrier removal, an AllKare Adhesive Remover wipe may be used to remove any adhesive buildup