ConvaTec SUR-FIT Natura Two-Piece Cut-To-Fit Durahesive Skin Barrier With Tape Collar

Convatec SUR-FIT Natura Durahesive Skin Barrier Features

• Comes with flexible white or tan tape collar for increased flexibility
• Simple snap-off, snap on design allows users to change the urostomy pouch quickly to match activities without removing the skin barrier from the skin
• Coupling ring provides audible click confirming secure connection to skin barrier
• Provides added protection from liquid output
• Gently swell up and hug the stoma, better protecting the skin around stoma
• Easy to fit, apply and remove
• Latex free

What to buy with SUR-FIT 413164 Durahesive Skin Barrier W/Tape Collar

• ConvaTec AllKare Adhesive Remover Wipe
• ConvaTec SUR-FIT Loop Ostomy Rod
• Tytex CareFix StomaSafe Plus Ostomy Support Garments

How to use Convatec SUR-FIT Cut-To-Fit Durahesive Skin Barrier

• Sur-Fit Natura System
  - Begin by cleansing the peristomal skin with mild soap and water (soaps should be free of oils and creams). Pat dry thoroughly.
  - The skin should be free of any solvent or greasy substances.
• Preparation
  - Measure the stoma size with the measuring guide provided. Select a skin barrier/wafer with a flange (white ring) that is at least 1/2" (13mm) larger than the widest diameter of the stoma. If this size is not available, go to the next larger flange size.
  - Trace the exact stoma size onto the center white release paper in the back of the skin barrier/wafer. The small starter hole should be in the center of your tracing.
  - Cut along the tracing with curved, short-blade scissors. For skin barriers/wafers with precut stoma opening: Select a skin barrier/wafer with a precut stoma opening the same size as the largest diameter of the stoma. Do not enlarge the precut stoma opening. Remove white release paper from the skin barrier/wafer. Leave the outer release paper on the tape collar in place.
  - Stomahesive Paste can be applied to the back of the skin barrier/wafer to further fill gaps between the skin barrier/wafer and the stoma. Allow the paste to set for one minute prior to application to the skin. (Do not spread the paste.)
• Application
  - Center the skin barrier over the stoma. Press the skin barrier against the skin.
  - If using a tape bordered skin barrier, remove the remaining backing paper one side at a time.
  - During application, maintain gentle pressure on the skin barrier for 30 seconds to improve adhesion.
• Removal
  - Gently pull the skin barrier down, away from the skin, while supporting the adjacent skin with your other hand
  - To assist with the barrier removal, an AllKare Adhesive Remover wipe may be used to remove any adhesive buildup.