Colo-Majic Biodegradable Liners

Features of Colo Majic Liners

• It no longer requires the user to poke holes in it
• Simply remove liner from the pouch when half full and discard
• Ideal for those with any 2-piece colostomy, ileostomy, and urostomy pouch

What to buy with Biodegradable Liners

• Cymed Stoma Cap With Charcoal Filter
• SealTight Shower Patch Shield
• Trio Siltac Silicone Ostomy Seal

How to use Colo Majic Biodegradable Liners?

Colo-Majic Liners are easy to use. Their patented design features make inserting them into an empty pouch, removing, and flushing them very simple. Note: Always handle Colo-Majic Liners with dry hands!

1. Preparing the Colo-Majic Liners for use
   If you’re concerned about the gas buildup, you will want to poke a few air holes into the shoulders on each side of the liner, outside the seals, and below the narrow section of the liner. The seals are designed to allow air to pass upwards while preventing liquid from passing through the air holes. Using the pin provided, poke two or three holes on each side of the liner. Your liner is now ready for use.
   Note: To save time, you can create air holes in multiple liners together. Simply stack the liners together like you would sheets of paper and poke through them.
2. Preparing your two-piece ostomy pouching system for liner use
   When new, the ring seals that create the bond between the flange (or wafer) and the pouch can sometimes be stiff. After separating the ring seals several times, the rings tend to snap together with greater ease. To make snapping the ring seals together with the liner the first time easier, try adding a couple of very small drops of liquid hand soap in the groove of the ring seal on the pouch. You can use a Q-tip or a toothpick to work the drops around the entire circumference of the grooved ring seal.
3. Inserting the unused liner into the ostomy pouch 
   • Step 1: Squeeze it and push it into the pouch opening
     Note: To make this easier, blow the pouch open with a little air prior to inserting the liner
   • Step 2: Insert a couple of fingers into the Colo-Majic Liner opening and evenly spread the liner inside the pouch.
     Note: You can also blow a little air into the liner to push it open inside the pouch
   • Step 3: Spread the Colo-Majic Liner opening around the pouch opening evenly and then seal the pouch to the flange ensuring about 1 inch of liner material is visible around the outside of the ring once the seal is made.
     Note: Always double-check the ring is sealed properly between the pouch and the flange, especially when the flange is already applied to your skin
4. Removing the used liner from the ostomy pouch
   • Step 1: Remove the pouch from the flange
     Note: When the flange is attached to your abdomen, use one hand to apply firm pressure to the flange when separating the pouch to prevent lifting the flange of your skin
   • Step 2: Grasp the liner from the edge and pull it together to seal the contents inside the liner
   • Step 3: Gently pull the liner and its content out of the pouch opening, deposit it into a toilet, and flush
     Note: If you’re worried about spillage, simply overturn the pouch into a toilet and let the contents and liner fall out on their own