Bard Silastic 2-Way Standard Specialty Foley Catheter With 5cc Balloon Capacity

Bard Silastic Two-Way Standard Specialty Latex Foley Catheter With 5cc Balloon Capacity comes with smooth, non-stick silicone exterior coating which reduces calcification build-up. It helps maximize stiffness without compromising flexibility.

What does Silastic Two-Way Standard Catheter Include?

• Firm, but flexible, latex-based construction
• Large drainage lumen
• Short round tip
• Two opposing drainage eyes

Bard Silastic Standard Specialty Foley Catheter Features

• Delivers maximum comfort and patient protection from irritation
• High quality ribbed balloon with exceptional strength, symmetrical inflation characteristics and proper positioning of the catheter tip within the bladder
• Hollow urinary drainage tube is held in the bladder by a small, water-inflated balloon
• Silicone-Elastomer coating

How to use Bard Silastic Foley Catheter?

• Foley catheter acts as a drain to empty the bladder
• It is a thin, hollow tube made of soft, flexible material
• It is passed through the urethra into the bladder
• The catheter is held in place by a small water-filled balloon which is inflated in the bladder to keep the catheter from falling out while one goes about his normal activities
• Urine will automatically drain out of the bladder into the bag which is attached to the catheter

• Ensure that the Bard Foley catheter balloon is positioned well within the patients bladder. Slowly, with a gentle, constant force, inflate the Bard Foley catheter balloon with the volume prescribed on the package
• Note that the 5cc balloon must be inflated with between 9cc to 10cc of sterile water
• Improperly inflated Bard Foley catheter balloons may cause drainage and deflation difficulties
• Using fluid other than sterile water may cause the balloon not to empty properly, especially after long dwell times

• Select a luer slip syringe
• Slide the plunger of the syringe up and down the barrel of the syringe several times to loosen it up
• Compress the plunger all the way and then pull back the plunger slightly so that it does not adhere to the front of the syringe barrel
• Gently insert the syringe in the catheter valve
• Do not use more force than is required to make the syringe stick in the valve
• Allow the pressure within the balloon to force the plunger back and fill the syringe with water
• If you notice slow or no deflation, re-seat the syringe gently. Once again, allow the balloon to deflate slowly on its own
• If the balloon does not deflate, reposition the patient.
• Ensure that the catheter is not in traction, the proximal end of the catheter is not compressed within the bladder neck
• Ensure that urine flows freely
• Attempt to deflate the balloon by using the pressure in the balloon to force water into the syringe as described above
• If the balloon stills fails to deflate, apply very gentle slow aspiration. Aspiration that is too rapid, or too forceful, may cause the inflation lumen within the Foley catheter to collapse
• If permitted by hospital protocol, the valve arm may be severed
• If this fails, contact an adequately trained professional for assistance, as directed by hospital protocol

What to buy with 2-Way Specialty Catheter

• Dale Hold-n-Place Foley Catheter Holder 
• Personal Medical C3 Male Incontinence Device
• Cardinal Health ReliaMed Lubricating Jelly