3M Scotchcast Plus Casting Tape - 3'' x 4yd

3M Scotchcast Casting Tape Features:

• Water-activated resin lets you control working time according to application needs
• High and early strength allows for weight bearing in 20 minutes 
• Provides a durable cast with less chance of breakdown and the need for costly repairs or replacements
• Lightweight for easy mobility
• Porous weave allows the skin to breathe
• Stretches to conform well to contours for a more comfortable, better-fitting cast
• Water-activated resin: Gives control of set time for both basic and specialty casting applications
• Tack free: Gives ease of roll unwind during application and enhanced glove movement during molding, thus improving lamination
• Multi-directional extensibility: Scotchcast Plus casting tape conforms well to contours, improving cast fit and appearance.
• Durable: Strong, water-resistant, and hard-wearing
• Lightweight: The fiberglass construction of Scotchcast Plus tape allows for ease of mobility
• Porous: Scotchcast Plus casting tapes allow the skin to breathe
• Improved finish: Scotchcast Plus tape has an improved finish to help prevent scratching skin or snagging clothes
• Also Available (Separately):
   - 3M Scotchcast Plus Casting Tape - 2'' x 4yd
   - 3M Scotchcast Plus Casting Tape - 4'' x 4yd  

When to Use 3M Scotchcast Plus Casting Tape?

• Intended for use in the construction of most common orthopedic casts, as well as specialized prosthetics and orthotic devices
• Specific application suitability should be the responsibility of a qualified, on-site medical professional

How to use 3M Scotchcast Casting Tape?

• Slip one or two layers of 3M Stockinet over the affected part or wrap with 3M Cast Padding. If desired, additional cast padding may be used for greater protection of pressure points and bony prominences.
• It is important to use 3M water-shedding stockinet and cast padding to enable thorough drying if the cast should be immersed in water
• Gloves must be worn while wrapping the casting tape since the resin in the tape will transfer and adhere to the skin.
• Select the desired width of Scotchcast casting tape.
• Immerse the roll of tape in room temperature water 70-75°F (21-24°C).
  NOTE: To lengthen the set time, immerse the roll in cold water and remove it immediately without squeezing. This technique will give a set time of approximately 4 minutes. When using Scotchcast Plus casting tapes, there may be a decrease in slipperiness if the roll is not squeezed while submerged in water. If the roll is immersed in water above 80°F (27°C) an increase in exotherm may be noted.
• Construct the cast by wrapping spirally, overlapping the previous turn one-half to two-thirds the width of the tape.
• Avoid excessive tightness.
• Just three or four layers provide a strong non weight-bearing cast and five to eight layers are typically adequate for weight-bearing cast.
• Additional layers are generally not necessary for strength and will reduce porosity.

Precautions:

• The polyurethane resin will adhere firmly to unprotected skin and to clothing.
• Care should be exercised to avoid contacting unprotected areas of the patients skin during application.
• One should allow the material to fully cure before touching with unprotected skin.This takes about 30 minutes.
• If water immersion is anticipated, the casted extremity must be prepared with a suitable water-shedding stockinet and/or cast padding.
• Patients must be thoroughly instructed in techniques of drying their casts if they become wet, as prolonged or too-frequent wetting or ineffective drying can lead to skin maceration or other complications.
• Maximum strength is achieved when cast is thoroughly dried.