Get 10% Off* + $15 Reward$ | Code: HPFYJN

Day
:
:
Online since 2002 |   866-316-0162

Drive Chad CGA 870 Oxygen Regulator

Authorized Retailer Badge

Options

Item# Description Pkg reward$ Price Blank
Item #: CH4808-L-BLUE
0-8 LPM, Click Style Blue Regulator
Each
Each
reward$
$3.22
$90.15
$64.39
Item #: CH4815-L-BLUE
0-15 LPM, Click Style Blue Regulator
Each
Each
reward$
$3.33
$93.25
$66.59

Drive Chad CGA 870 Oxygen Regulator offers a multitude of liter flow options. The Barb Outlet will connect to a humidifier or an adapter is needed to connect directly to a cannula. The ergonomic T-handle makes tightening quick and pain-free. A sleek blue finish gives this oxygen regulator some flare.

Drive Chad CGA 870 Oxygen Regulator Highlights:

  • 20-micron
  • Barb Outlet
  • Sleek blue finish
  • Ergonomic t-handle
  • Sintered-bronze inlet filter

Features of Drive Chad CGA 870 Oxygen Regulator

Oxygen Flow Control Regulators:


  • Pressure reducing devices which lower oxygen pressure from a cylinder to levels that can be safely used by the user
  • Intended for the administration of oxygen to patients who need increased oxygen levels to improve their breathing conditions
  • In addition, some models may be used in emergency situations
  • In an emergency situation, be sure to contact a physician or EMS immediately
  • 100% quality QC tested in the USA
  • 20-micron, sintered-bronze inlet filter
  • All flows tested to an accuracy within +/- 15% tolerances
  • Ergonomic t-handle for easy tightening
  • FDA recommended Viton and brass seal washers
  • Inlet pressure:
    - 200-3000 PSI
  • Outlet pressure:
    - 50PSI

More About Drive Chad CGA 870 Oxygen Regulator

  • Use:
    - Be sure the regulator is in the "off" position by rotating the knob counterclockwise to the "0" position.
    - For safety, be sure you are not directly in front of or behind the regulator when opening the cylinder valve.
    - Slowly turn the cylinder valve on (counterclockwise), about one full turn.
    - If you can hear a hissing sound, there is a leak in the system. Turn the cylinder off and turn the regulator on to relieve any built-up pressure.
    - Try tightening the regulator to the cylinder and opening the cylinder again. If this does not help, shut the system down again and contact a service representative.
    - Never attempt to repair a regulator or cylinder yourself.
    - Adjust the flow rate setting by turning the knob clockwise until the desired setting shows through the window.
    - If the cylinder pressure falls below 300 PSI, you should exchange the cylinder for a full one
    - To turn off the system, close the cylinder valve, wait for oxygen to flow out of the regulator, and turn regulator to the "0" position.
    - Never try to remove the regulator unless the cylinder is off and pressure has been relieved.

  • Set Up:
    - Inspect and install the cylinder using instructions of qualified personnel.
    - Be sure to purge the cylinder valve seat of debris.
    - Inspect the regulator for oil or grease. If these are visible, do not use the regulator.
    - Be sure the sealing washer is in place in the yoke inlet.
    - Slip the yoke over the cylinder post and fit the pins into the holes on the cylinder valve. The pins should fit easily into these holes.
    - Turn the t-handle clockwise until the screw point is seated in the dimple on the cylinder valve.
    - Be sure the regulator is tightened snugly onto the cylinder. Attach the oxygen supply tubing to the barbed outlet connection.

  • Warnings:
    - Federal law restricts this device to use by or on order of a physician. Only use as prescribed by a physician.
    - This unit should only be used on patients who are breathing; do not use to resuscitate non-breathing patients.
    - Do not use with oil, grease or any other flammable material. Keep out of reach of children.
    - Do not smoke in an area where oxygen is in use.
    - Do not use this equipment unless you have been trained in its proper use or are under the supervision of someone trained in its use.
    - If the pressure relief valve on the underside of the regulator begins to vent oxygen, turn off the system and remove the unit until it can be serviced.

Customer Reviews

{{x.Heading}}

{{x.ShortDescription}} ...

Share

Please enter your and your friends email address below.

Fields marked with * are compulsory

Your Name*
Your Email Address
Friend's Name*
Friend's Email Address
Message
The selected product information along with Reward Dollar coupon code has been successfully emailed to you and your friend.

Thank you for using www.healthproductsforyou.com

Close