Bio Compression 4 Chamber Half Leg Garment

4 Chamber Half Leg Garment Features

• To be used with either Pump Model SC-2004, SC-2004-OC, SC-2004-FC-OC, SC-3004 or SC-3004-DL
• Helps to move lymph fluid out of swollen limbs
• High quality and durable materials to ensure longevity
• Adjustable version designed for the difficult to fit and offers a Standard Mode (the flap is tucked back into the garment) and a Expanded Mode (the flap remains outside of the garment)
• Length: 19"
• Also Available (Sold Separately):
  - Bio Compression 4 Chamber Sequential Circulator 2004-OC
  - Bio Compression 4 Chamber Digital Sequential Circulator 3004-DL

More On 4 Chamber Half Leg Garment

• Clean the exterior case and tubing with a damp (not wet) cloth using a mild soap and water solution once per month or as needed.
• Do not allow liquids to enter the equipment, an electrical hazard may be presented.
• Always allow the unit to dry before re-using.

• Disconnect garment and tubing from device.
• Open garment to expose all sides either by separating Velcro type hook and loop or by unzipping (depending on type of garment).
• Use either a large sink or plastic tub able to hold enough solution (depending on size and quantity of garments) to completely submerge garment/s under water including tubing, with the exception of connectors at end of tubing. Solution should consist of 1/3 cup of Tide or equivalent detergent per 1 gallon of warm tap water.
  Note: It is extremely important that connector at end of tubing be kept out of water at all times to avoid water from entering interior portion of garment/s.
• Garment/s should be soaked for 1/2 hour with mild agitation of garment every 5 to 10 minutes while keeping it below surface of water.
  Note: Occasionally, harder to remove soiling on surface of garment may require additional washing by hand with a clean towel or soft brush while submerged. In all cases, avoid using any abrasive type materials on the exterior surface of garment.
• Thoroughly rinse garment with warm tap water.
• Re-submerge garment in solution consisting of 1 cup of Clorox bleach per gallon of warm tap water for 1/2 hour, again agitating garment every 5 to 10 minutes while keeping garment/s below surface (with exception of tubing connector/s).
• Rinse garment/s thoroughly and allow to air dry.
• Do not place garment in washing machine or submerge in water. It is important to keep water from entering interior portion of garment where ultimate damage can occur to the pump.
• Do not use the tubing or valves as "handles" for carrying, hanging or storing garment/s.
• In cases when it is necessary for a garment to be returned to the factory for repair or evaluation, it is essential that garment/s are thoroughly cleaned and disinfected.