Optec Oasis LSO LumboSacral Back Support Orthosis

When to use Oasis LSO Lumbar Support Belt?

• Burst Fx
• Chronic back pain
• Compression fractures
• Degenerative, herniated or bulging disc
• Laminectomy
• Osteoporosis
• Paraplegia
• Post-operative
• Spinal stabilization
• Spinal stenosis
• Spondylolysis
• Spondylolisthesis

LumboSacral Back Support Orthosis Standard components

• Corset back and front
• Anteriror polymer panel
• Posterior polymer panel
• Lateral polymer panel

What to buy with Optec Oasis LSO Brace

• Sombra Cool Therapy Natural Pain Relieving Gel
• Chattem Icy Hot Medicated Patch

Oasis LSO LumboSacral Back Support Brace Patient Fitting Instructions

• Place the Optec Oasis LSO Brace around your waist with the side closure pre-attached to the left side of the front panel. Proceed to attach the right hook and loop attachment to the right side of the front panel.
• Align the orthosis so that front panel is centered over your abdomen and the center of the back panel is aligned over your spine.
• Using the arthritic thumb grips, detach the bottom compression straps and pull straps simultaneously away from your body.
• Secure the left strap to the center of the orthosis followed by the right strap. Repeat for top strap if applicable.
• Finally, ensure that the orthosis fit is snug and does not cause any discomfort.
• For best results, re-tighten the straps while lying on a bed with your knees bent and feet flat.

Care Instructions for LumboSacral Back Support Orthosis

• Always wear a t-shirt or orthopedic body sock under your orthosis.
• To clean the orthosis, hand wash it with mild soap in cool water.
• Allow the orthosis to air dry.
• It is not uncommon for your body to change size while wearing the orthosis because of the compression and reduction in post-surgical swelling.
• If you change enough in size that you can no longer adjust the straps to achieve compression, see your practitioner for a follow-up visit to resize or replace your brace