Invacare Trapeze Bar And Handle

Invacare 7740A Trapeze Bar With Two Piece Design Features

• Two-piece design secures with an added locking pin for extra safety
• The horizontal bar in the handle allows for additional grip
• Heavy-gauge, octagonal steel construction for added durability
• Easy, tool-less assembly
• Safe working load of 168 lb
• Height adjustable
• This trapeze bar and handle can be installed on any Invacare home care bed end
• No tools required for an easy assembly
• Wall bumpers and padded mounting brackets protect bed and wall surfaces

What to buy with Invacare trapeze equipment?

• Invacare Trapeze Floor Stand
• Invacare Wall Bumper with Horns
• Mabis DMI Twin Folding Bed Board
• Rose Healthcare Contour Fitted Sheets For Hospital Beds

How to Install Invacare Trapeze Bar And Handle?

Installing the Trapeze

1. Install the upper bracket and lower bracket onto the floor base or bed end . Refer to Attaching Brackets to Floor Base, or Attaching Brackets to the Bed End
2. Put the lower offset bar through the clamp on the upper bed bracket and through the socket in the lower bed bracket
3. Securely tighten the wing nut on the clamp on the upper bed bracket to hold the lower offset bar in place
4. Put the upper offset bar onto the insert bar that is welded onto the lower offset bar
5. Make sure the upper offset bar is fully seated
6. Place the lock pin through the holes in the upper offset bar and insert
7. Secure the D-loop around the pin
8. Secure the lanyard through the lock pin loop and through the upper offset bar
9. Adjust the height and/or position of the trapeze

Installing/Adjusting the Grab Bar

1. Loosen trapeze key by turning counter clockwise
2. Slide the clamp to desired position on the upper offset bar
3. Secure the trapeze clamp to the offset bar by turning the key clockwise