Invacare Reliant Linak Battery Pack 1078276

How to Charge Linak Battery?

1. Lift up on the handle on the back of the battery.
2. Lift the battery up and out away from the control box.
3. Place the battery on the battery charger as shown. Make sure there is an audible click.
4. Lift up on the handle on the back of the battery.
5. Lift the battery up and out away from the battery charger.
6. Reinstall the battery onto the control box as shown. Make sure there is an audible click.

• Invacare recommends the battery be recharged daily to prolong battery life.
• An audible alarm will sound (horn will beep) when battery is low.
• Make sure there is an audible click when mounting battery on the battery charger to confirm proper mounting. Otherwise, injury or damage may occur.
• When charging is complete, charge LED will stop illuminating.
• A battery needing to be fully recharged will take approximately four hours.

Linak Battery Specifications

Customer Reviews

Questions & Answers

Ask a Question

Enter your question below:

 

Security question 2+ 6 =   SubmitCancel

Enter your Answer below.

Security Question:2 + 6 =

	ItemQuestion ItemName - now
	Your question will show here once it will get approved.

	UserAnswer UserName - now Your Answer will show here once it will get approved.

How to mount the charger on the wall? Zain - 1/17/2017 5:20:29 AM

ReplyShare

Follow the given instructions to mount the charger: - Place the battery charger with mounting bracket on the wall at the required position - Take a pencil and mark the middle hole position - Measure down 6-1/2 inches from the pencil mark and drill the first mounting hole - Install the bottom mounting screw till there is an approximate gap of 1/8 inch between the screw head and the wall - Install the battery charger with mounting bracket on the bottom mounting screw - Drill the two remaining mounting holes - Install the remaining two mounting screws through the mounting bracket into the wall - Tighten it securely - Plug the battery charger in the wall electrical outlet - Verify that “ON” is illuminated Customer Care - 1/17/2017 11:09:40 PM

Will this Battery Pack work with my product code #RPS350-1? Mochael - 1/17/2017 5:19:46 AM

ReplyShare

	Yes, Invacare Reliant Linak Battery Pack is compatible to work with all the Reliant Power Lifts including your product code #RPS350-1. Customer Care - 1/17/2017 11:06:22 PM

what is the best way to save the lift of the battery? put on charger every night or wait tell it runs down almost all the way to charge? PAMELA J TWOMBLY - 8/19/2016 1:45:47 PM

ReplyShare

	Thank you for contacting customer care service. To improve battery life, let the battery drop down to 20% and recharge it again. Never let battery drop to zero. Customer Care - 8/20/2016 1:41:15 AM

What are the product dimensions? Do the 6 screws get removed to reveal the sealed lead acid batteries inside? Derek - 5/15/2016 6:00:42 PM

ReplyShare

	Unfortunately we do not have the dimensions. For warranty to not be voided it is not recommended that the casing be taken apart to reveal the batteries inside. Customer Care - 5/17/2016 1:03:23 AM

Will it work on Liko Light hoyer lift? Don - 2/3/2016 12:16:45 PM

ReplyShare

	Thank you for your inquiry. The Invacare Reliant Linak Battery Pack is to be used with Reliant Power Lifts only. Customer Care - 2/3/2016 11:48:23 PM

Linak replacement battery comes with charger, cable ,bracket ? do you guys have cable for Europe? Kate - 9/24/2015 8:27:55 AM

ReplyShare

	Thank you for reaching out to us. No the charger does not come with the battery pack, it is the battery only. Customer Service - 9/25/2015 12:34:39 AM

will battery 1078276 be the same as baj10000 1011? Joanne - 9/24/2015 8:25:20 AM

ReplyShare

	Thank you for reaching out to us. Yes it is. Customer Service - 9/24/2015 8:26:03 AM

Is it made in USA? Barbara - 9/24/2015 8:21:46 AM

ReplyShare

	Thank you for contatcing us. No, it's country of origin is China. Customer Service - 9/24/2015 8:22:50 AM