Cardinal Gates Stairway Special Outdoor Safety Gate

Cardinal Gates Stairway Special Outdoor Safety Gate Features

• Latch system that baffles toddlers yet allows one hand operation for adults
• Stainless steel hardware, no plastic parts to break or wear out
• Powder-coated finish with stainless-steel hardware, ensuring that it is rustproof and weatherproof
• Hardware mounted for maximum strength
• This safety gate includes all necessary hardware

What to buy with Stairway Special Outdoor Safety Gate

• Cardinal Gates The Patio Door Guardian Lock
• Cardinal Gates Hearth Padding
• Cardinal Gates Clear Outdoor Deck Shield

Cardinal Gates Outdoor Safety Gate Assembly Instructions

1. Install hinge bracket to wall (stationary side of gate) using Phillips screw drill pilot hole 6 ” above floor surface. (Use ruler on left edge of this sheet to measure from floor). OPTION: Long screws maybe be used to attach gate to stud through dry wall.
2. Install second screw in top of hinge bracket securing it to the wall
3. Insert eye bolts with nut and washer into top and bottom of hinge side gate (side with three holes). Be sure nuts are tight. Do not use middle hole for this step
4. Hang gate by inserting hinge rod, through top of mounted hinge bracket, through upper plastic shoulder washer, through both eye bolts, through lower plastic shoulder washer, and finally through bottom of hinge bracket. To secure hinge, insert key ring through hole in end of hinge rod. Gate can be mounted at angles up to 30 degrees.
5. Mount latch assembly to gate using 3/4” bolts with serrated washers. Attach wall mount for latch assembly up into part that is now secure on gate. Slide gate out to mark holes for on attaching wall. (OPTIONAL ONE WAY BRACKET INSTALLED HERE) Then attach the wall mount of latch assembly to wall using Phillips head screws. Optional long screws maybe be used to attach gate to stud through dry wall.
6. Keep gate closed and latched. Use Allen wrench to insert set screws in the upper and lower brackets of the gate. Tighten the set screws to set the width of the gate.

Cardinal Gates Operation

• For Opening - When approaching gate, if latch is to your left, use right hand. Depress flip latches simultaneously with thumb and index finger while lifting gate with remaining fingers of hand.
• For Closing - Grasp gate in middle. Lift gate and align latch pins with bracket holes. Drop in place. There is no need to close gate using flip latches.

Stairway Outdoor Saefty Gate Maintenance

• When used outdoors it is suggested to spray hinge and latch parts with a marine corrosion inhibitor by CRC or equivalent. This can be obtained normally at marinas or auto parts stores. Remove set screws when separating frames for cleaning. Please call for information.
• To clean, cardinal gates stairway special outdoor child safety gate rinse it with lukewarm water, wash gently with mild soap or detergent and lukewarm water, using a soft cloth or sponge. Rinse again. Dry with a soft cloth or sponge to prevent water spotting. Do not scrub or use brushes or squeegees.

How to care for Stairway Special Safety Gate?

• Close gates gently. Do not slam. To prevent damage to latch mechanism.
• When closing, be sure safety bracket on gate frame engages as depicted in instructions.
• Children should not be allowed to swing on an open gate as this can damage hinge mount.
• Keep allen wrench in a secure place. Removing set screws when separating sections for cleaning. Periodically check all screws, bolts, etc. for security and proper adjustment.

Cardinal Gates Stairway Special Outdoor Safety Gate Manual