Kaz Vicks Ultrasonic Cool Mist Humidifier

Features

• Instruction Manual

More Information

• Important Safety Instructions:
  - Always place humidifier on a firm, flat, level surface
  - Keep cord away from heated surfaces and out of the way, where it can not be stepped on or tripped over
  - Before using the humidifier, extend the cord and inspect for any signs of damage. Do not use product if cord has been damaged
  - To avoid the risk of fire, shock or personal injury, do not use an extension cord
  - Humidifier should always be unplugged and emptied when not in operation or while being cleaned
  - Shut off and unplug humidifier before moving. Do not move or tilt humidifier while it is operating. Plug and unplug unit with dry hands
  - Do not operate without water. Turn off unit when tank is empty
  - Do not add any medications (e.g., do not add Kaz Inhalant or Vicks VapoSteam) into the Nozzle, Base, Reservoir or Water Tank
  - Do not cover, or insert objects into, any openings on the unit
  - Do not immerse the Base in water or other liquid. Do not overfill
  - Do not operate outdoors, this appliance is intended for indoor use
  - Do not place in direct sunlight, high-temperature areas, or near computers or sensitive electronic equipment
  - This product has a polarized plug (one blade is wider than the other) as a safety feature
  - This plug will fit into a polarized outlet only one way
  - If the plug does not fit fully into
  the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature
  - The humidifier should not be left unattended in a closed room since air could become saturated and leave condensation on walls or furniture. Leave room door partly open. Do not aim Mist Nozzle directly at children, walls or furniture
  - Do not place the humidifier directly on wood furniture or other surfaces which could be damaged by water. Protect by placing the humidifier on a non-metallic waterproof surface
  - Do not touch the Nebulizer while the unit is plugged in as burns could result
  - Do not block the Scent Pad Heater air flow
  - Do not place exposed Vicks VapoPad on furniture, fabrics, bedding or plastics
  - Do not touch skin with exposed Vicks VapoPad
• Operating Instructions:
  - Do not operate the humidifier without water in the Water Tank
  - After filling the humidifier, be sure the Power Knob is in the OFF position, then plug the power cord into a 120 volt AC wall outlet
  - Turn the Power Knob to the On position and then set mist intensity
  - Mist will not appear immediately; allow a few minutes for the water to fill the Reservoir. If you are using a new Demineralization Cartridge, it may take up to fifteen minutes for the filtering material to become saturated and for mist to appear
  - Direct Mist Nozzle away from walls and furniture. If condensation forms on walls or windows, or if indoor relative humidity exceeds 50%, reduce mist intensity setting, open door to room where humidifier is operating, or turn unit off
  - If mist is not produced, unplug cord and check the Water Sensor in the Reservoir to ensure it is in contact with the water. The water level in the Base must be high enough to partially immerse the Water Sensor in order for the humidifier to work
  - Turn the humidifier off before removing and refilling the Water Tank. When the tank is empty the mist will stop although the fan will continue to operate
• Daily Maintenance:
  - Turn off and unplug your humidifier
  - Remove Water Tank and set aside
  - Gently pull old scent pad out of the slot and discard
  - Open refill pad and insert
• Care and Cleaning:
  - Lift the Water Tank from Base and empty all water from the Reservoir. Remove the Tank Cap and drain any water from the Water Tank. Wipe it clean with a soft, damp cloth. The Mist Nozzle should be removed during cleaning to prevent damage
  - Do not immerse the Base in water. Gently wipe the Reservoir with a soft, clean, wet cloth.
  Do not attempt to remove or in any other way modify the Water Sensor. Use care when wiping around the Water Sensor; it is delicate and can be easily damaged. Rinse the Water Tank with lukewarm water after each use. For storage, wipe dry with a soft, clean cloth. Keep water away from the Air Outlet
  - Do not use detergent to clean any water-containing parts of the humidifier. Detergents and the film they leave behind can affect the output of the humidifier. Do not use abrasive cleansers or brushes
  - Do not leave water in the Water Tank or Reservoir when unit is not in use as it may result in the build up of mineral deposits and bacteria that can inhibit the output efficiency of the humidifier. Please note that if water remains in the Water Tank for more than a day or two, bacterial growth is possible