Battery Power Solutions ResMed 24V Power Converter For Air 10 And S9 Series

More Information

• Important Connections:
  - The connection steps must be followed in exact sequence in order to initiate the voltage conversion process and thus allow the CPAP Battery to power the device. After the connection if you are not receiving power to the device unplug all components and follow the instructions again.
  Single Battery Connection:
  - Plug the 24V power converter box into the DC OUT jack of the battery.
  - Plug the appropriate output cord for your device (Air 10 or S9) into the power converter box.
  - Plug the 24V power converter (with appropriate device output cord attached) into the DC input port of the ResMed Air 10 or S9 device.
  - Turn on the PAP device and it should begin functioning.
  - When not in use disconnect all devices from the battery thus allowing the battery to completely shut down.
  Dual Battery Connection:
  - Plug the DC power pigtail cord included with the CPAP battery kit into the DC OUT jacks of both batteries.
  - Plug the appropriate output cord for your device (Air 10 or S9) into the power converter box.
  - Plug the 24V power converter (with appropriate device output cord attached) into the DC input port of the ResMed Air 10 or S9 device.
  - Turn on the PAP device and it should begin functioning.
  - When not in use disconnect all devices from the battery thus allowing the battery to completely shut down.

Specification

Warranty

Customer Reviews

Questions & Answers

Ask a Question

Enter your question below:

 

Security question 3+ 4 =   SubmitCancel

Enter your Answer below.

Security Question:3 + 4 =

	ItemQuestion ItemName - now
	Your question will show here once it will get approved.

	UserAnswer UserName - now Your Answer will show here once it will get approved.