Homecraft Alton Bath Board

How to Use Alton Bath Board?

• Loosen the wing nuts that fasten the brackets to the bottom of the board. Slide the brackets as far toward the center of the board as possible.
• Place the board on the bathtub, being sure that the board rests securely on both sides of the tub without excessive overhang.
• Move the brackets toward the sides of the bathtub until they are snug against the sides. The brackets can be placed at an angle to accommodate curvature of the tub.
• Tighten the wing nuts securely.
• Repeat the fitting procedure each time the bath board is placed on the bathtub.
• The bath board can be used with a bath seat that enables the user to sit lower in the bathtub.

• The board can be cleaned with a household disinfectant or mild detergent and water

• The bath board is not to be used to support more than 190kg / 420lb / 30st.
• Both ends of the bath board must be supported securely by the sides of the bathtub.
• Avoid excessive overhang, which may result in tipping of the bath board.
• Be sure the bath board is securely in place and the brackets are snug against the sides of the tub before putting weight on the board.
• Use of a slip-resistant bath mat is strongly recommended.
• Cover the bath board with a towel to help reduce slipperiness.

Customer Reviews