Winco Three Position XL Convalescent Recliner

Winco Three Position XL Convalescent Recliner Features

• Elastic bands on back frame and seat that provides enhanced comfort and support
• 3 position lock allows for safe, secure and comfortable positioning
• Comfortable, padded armrests with scuff guards to keep upholstery free from damage
• Non-porous, fold down side tray contains small spills. Standard on right and left sides
• Recessed hand grips assist in entering and exiting the chair
• Removable side panels for easy cleaning and maintenance
• 5" total lock casters (in rear) allow for better handling and control
• Note:
  - SilverTex is not recommend for applications involving frequent contact with bodily fluids where bleach is the preferred or required cleaner. Bleach is not advised for cleaning SilverTex

How to Assemble Winco Convalescent Recliner?

• After checking your product for any shipping damage, chair needs to be positioned upright on level surface. Remove packing material and hardware  that was secured for shipping. Cut tape and plastic with scissors, being careful not to damage upholstery.
• Make sure footrest is in closed position and lock all casters before installing chair back.
• Remove the (2) Bow Tie Cotter Pins and the (2) Clevis Pins from the lower Back Frame Forks. Do not lose these parts, you will need them again.
• Using a second person to help; Position the Back Frame Forks over the Seat Frame and align holes.
• Use (1) one of the Clevis Pins and insert it FROM the inside of Back Frame Fork, through hole in Seat Frame and, through outside of Back Frame Fork. Repeat for opposite side of chair.
• Insert (2) Bow Tie Cotter Pins, into the small holes on ends of the (2) Clevis Pins you just installed.
• Remove the Bow Tie Cotter Pins and the Clevis Pins from the Back Support Struts (attached to backframe)
• Align the holes of the Back Support Strut with the holes in the seat frame Angled Bracket and insert the Clevis Pins into these aligned holes and secure with the Bow Tie Cotter Pin.

• This recliner has three (3) positions; Upright, Semi-Recline, and Recline, which can be achieved by user or attendant. The position lock bar can only be engaged or disengaged by attendant. Not all notches on Position Lock Bar are used for this model chair. Only the 1st thru 4th notches can be used on the 5291 Recliner.
• Position Lock: Attendant may hold the chair in a reclined position by engaging the Position Lock. To safely accomplish this, recline the chair to the 2nd or 3rd recline position and lower the position lock with your hand until the notches on the Position Lock bars engage with the Position Lock Pins. To release Position Lock, raise the Position Lock off of the Pins and return chair to upright position.
• This chair is equipped with Total Lock casters. Stepping on the brake tab will lock the wheel and the swivel mechanism of the caster for added safety and security. 
• Side panels can be removed, for ease of cleaning, by unscrewing three (3) thumb screws on the inside of each panel.
• To ensure proper operation of the reclining mechanism, lubricate all pivot points with a silicone lubricant at least twice yearly.

• Remove grime, hair and body oils; Your furnishings should be cleaned with mild soap and water solution and a damp cloth on a regular basis (especially where skin and hair make contact with upholstery).
• Avoid harsh detergents or chemicals that could damage the upholstery or finish of your recliner.
• If the furnishing is disinfected with chemicals or bleach, it mus be wiped off using only clean water on a damp cloth and then be allowed to air dry. Failure to rinse upholstery with clean water can result in a build-up of residues over time that can dry out the upholstery and cause changes to the look and feel of the upholstery and eventually can lead to cracking.