Kaz Vicks Warm Steam Vaporizer With Safety Light

Kaz Vicks Warm Steam Vaporizer With Safety Light is used with medications to treat cold and flu symptoms. Relaxing steam vapors relieve respiratory symptoms for up to 10 hours. Vicks Steam Vaporizers produce a bacteria free steam to reduce the risk of further infection. The Kaz Vaporizer is unique, because it has a safety-light night light, preventing tripping at night. If you do not see the desired amount of steam after 10 minutes, add up to 1/8 teaspoon of salt to facilitate steam. Add salt in 1 pinch increments and do not add more than 5 pinches.

Kaz Vicks Vaporizer Features

• Vicks Warm Steam Vaporizer has automatic shut off feature
• Medicine cup for added relief when used with liquid inhalants
• Visible steam vapor
• Large night-light
• Exclusive non-rust carbon electrodes operate efficiently
• Operates up to 10 hours per filling
• 1 gallon capacity
• Color: Pink/White
• Wattage: 638 maximum

How to use Kaz Warm Steam Vaporizer?

• Unravel cord before use: Failure to do so could cause overheating and possible fire hazard. Always unplug cord from electrical outlet before removing steam unit or when not in use. Allow vaporizer to cool before handling.
• Fill water container: Remove steam unit. Fill container with tap water to Water level marking on bowl. Do not overfill. Model V200 Vicks Vaporizer may also be filled upright in large sink or bathtub.
• Add salt: For tap water of low or moderate mineral content, add 4 to 5 pinches (1/8 teaspoon) of ordinary table salt to the water and mix thoroughly. Salt has no effect on the purity of the steam or medication.
CAUTION: Too much salt can cause excessive boiling or blown fuse.
• Replace steam unit:. Hold down steam unit for ten seconds to allow water to enter the housing and seat it properly in water container. If steam unit floats, container is overfilled.
• Place vaporizer in a safe position: Vaporizer should always be placed on a firm, flat surface at least four feet away from bedside and out of the reach of patient and children. Be sure the vaporizer is in a stable position and power cord is out of the way to prevent vaporizer from being upset or tipped over.
Protect floor, rug or furniture by placing the vaporizer on a non-metallic, waterproof, heat-resistant surface.
CAUTION: Do not direct steam flow directly at patient, walls or furniture. You will still obtain desired level of humidity. Keep out of the reach of children. Steam can cause burns.
• Vaporizer Medications: For best results fill the medication cup on the steam unit (located directly below and in front of the steam outlet) with one tablespoon of Kaz Inhalant.
If you use Vicks VapoSteam follow directions on the VapoSteam package. Please pay careful attention to the added cleaning directions in the Daily Maintenance and Care and Cleaning sections.
NOTE: Vicks VapoSteam should be put directly into the vaporizer water container (see VapoSteam package directions); it should not be placed in the medication cup.
• Plug in: Plug power cord into 110-120 Volts AC outlet in good condition fused for at least 15 Amps. Do not use with extension cords.

How to clean Vicks Warm Steam Vaporizer Machine ?

Always disconnect the plug from the electrical outlet and allow the unit to cool before cleaning. Remove the steam unit, letting all water drain back into the container.

Do not attempt to disassemble the electrode-heating unit. Doing so will void our warranty and could damage the vaporizer or cause personal injury.

• Empty any unused water from the water container. Rinse container thoroughly with water, drain and wipe with a dry, clean cloth.

1. Empty any unused water from the water container. Rinse container thoroughly with water, drain and wipe with a dry, clean cloth.
2. With steam unit safely unplugged, soak steam unit in 3 1/2 inches of white vinegar for 10 minutes.
Then with fingers covering the bottom holes of the steam unit, add tap water into steam outlet. Cover steam outlet with finger of other hand, shake vigorously, then empty the water through steam outlet. Repeat several times until black particles are no longer emitted and vinegar odor is gone.
If using Vicks VapoSteam, make sure any residue is cleaned off steam unit using a mild detergent.
3. Be sure that Steam Outlet, Safety Vents (in front corners of night-light lens) and Water Intake Holes in bottom of steam unit are open and not clogged. Poke clean with a toothpick.
4. Disinfecting the Reservoir: Fill reservoir with water and add 1 teaspoon of bleach per gallon of water. Swish to wet all inner surfaces. Let stand for 20 minutes. Then empty reservoir and rinse with tap water until the bleach smell is gone. Dry with a clean cloth.

• Follow Weekly Maintenance procedure at end-of-season or when the vaporizer will not be used for several days. Be sure to dry all parts and store in a cool, dry location. Do not store unit with water inside.