Monark 827E Exercise Cycle

Monark 827E Exercise Cycle Features

• Training cycle with an adjustable brake resistance
• Equipped with an electronic meter showing pedal revolutions per minute (RPM), heart rate in bpm (HR), exercise time in minutes and seconds, calculated cycling speed in km per hour or miles per hour and distance in km or mile
• Specially designed for intensive use in institutions and gymnasiums
• Easy to use and tough
• Manual power control
• No power adapter is needed
• Weight Capacity up to 350 lbs

Monark 827E Exercise Cycle User Manual
 

Operating Instructions of Monark 827E?

Workload Device:

• The 827 E uses a brake belt system to control the resistance.
• The brake power can be changed by increasing or decreasing the tension of the brake belt against the flywheel using the tension knob

Cycle Adjustments:

• Seat height should be adjusted to a comfortable position.
• The appropriate height can be to have the knee slightly bent when the sole of the foot is centred over the pedal axle with the pedal to the bottom position.
• To adjust the seat height loosen the lever on the seat tube.
• The handlebar setting shall give a comfortable position when cycling.
• During longer exercise sessions it can be recommended to change handlebar position. To adjust the handlebar loosen the quick release lever
• NOTE: The handlebar stem should be inserted into the frame tube at least 3 inches (about 8 cm). This measure is marked with"MAX" on the stem.

Computer Instructions:

• Press the RESET-button or move the pedal to turn on the meter.
• At the display for heart rate (HR) a heart symbol is lit which means that the meter is trying to find a pulse signal from an external source (chestbelt with electrodes - not included).
• If the meter cannot find such a signal this HR function is automatically turned off after 30 seconds. When the function is turned off the heart symbol is not lit any more.
• The heart rate function can be turned on again by pressing the RESET button.
• The timer starts automatically when pedals are moved.
• Meter values for time and distance can be set to zero by pressing the RESET button for more than two seconds.
• Do not expose the electronic meter to direct sunlight or extremely high temperature.
• Do not use any dissolvents when cleaning.
• Use only dry cloth.