Rolyan Kwik-Form Progressive Hand Orthosis

Rolyan Kwik-Form Progressive Hand Orthosis Features

• Bilateral design fits left or right
  
• Hook and loop closures
• Cover sewn from comfortable, cool soft material for maximum compliance
  
• Includes removable machine-washable cover
• Indicated for for mild to moderate hypertonicity
• Latex free

More On Rolyan Kwik-Form Progressive Hand Orthosis

• Not for severe hypertonicity
  
  

• These splints are to be fitted initially by a healthcare professional who is familiar with the purpose for which they are prescribed. The healthcare professional is responsible for providing wearing instructions and precautions to other healthcare practitioners, care providers involved in the patients care, and the patient.
• If unusual swelling, skin discoloration or discomfort occurs, use should be discontinued and a healthcare professional consulted.
• Be careful that the straps are not so tight that they interfere with circulation.
• Recommended for use by only one patient.
  
  

• Rolyan Kwik-Form Splint bases have a removable cover
• Before cleaning, remove the cover from the splint and close all fasteners
  Splint base:
• Foam-covered splint base can be wiped clean with mild detergent
• Allow to air dry thoroughly
  Fabric cover:
• Place cover in mesh bag. Machine wash in warm water
• Allow to air dry thoroughly before replacing on splint
  Replacing cover:
• Replace cover on the splint
• After replacing cover, be sure fabric is smooth on splint base
  

The splint includes three straps with hook ends. The longest strap also has hook material attached to the center of one surface.
• Put the splint into position on the extremity to determine necessary modification. Bend the splint base to accommodate the level of flexion or extension. The distal projection cannot be modified.
• Attach the hook end of one strap to the ulnar surface of the distal volar projection.
• Choose the foam cone piece that best suits the level of flexion or extension. Put the cover on the cone and put the cone onto the distal projection of the splint over the hook end of the strap.
• With the splint in position on the extremity, wrap the distal strap across the fingers. Fasten the strap to the hook on the cover of the cone, continue wrapping under the thumb, and fasten it to itself.
• Place the hook piece in the center of the longest strap onto the volar surface of the splint at the level of the wrist. Wrap both strap ends diagonally across the dorsum of wrist and attach each to the opposite side of the splint.
• Attach the remaining strap proximally.