Rochester Spirit Style 3 Hydrocolloid Sheath Male External Catheter

Rochester Male External Catheter Features

• Designed for the management of male urinary incontinence
• Self-adhering male catheter eliminates need for tape or straps
• Kink resistant design helps ensure continuous urine flow
• Not made with natural rubber latex
• Adhesive width: 3"
• Sheath length: 3"

Rochester Catheter Hydrocolloid Adhesive

• Rochester Spirit Catheter takes advantage of the moisture-wicking properties of hydrocolloid which transport moisture to the breathable surface of silicone sheath where it can evaporate
• By preventing moisture buildup, hydrocolloid adhesive sheath helps protect skin integrity
• Hydrocolloid adhesive silicone sheath has the greatest degree of permeation

What to buy with Rochester Spirit Style Catheter?

• ProCare Catheter Strap
• Coloplast Brava Adhesive Remover Spray
• Urocare Uro-Bond III Adhesive Thinner
• Urocare Urofoam Adhesive Foam Strips

How to Use Rochester Spirit Style 3 Catheter?

• Sizing:
  Select the proper size. For comfort and effectiveness, choose the size closest to your penis width.
• Gather Your Supplies:
  You will need a Rochester Spirit Style 3 Catheter, a collection bag with connecting tube, non-pointed manicure scissors, soap (do not use soaps that leave a cream or greasy residue on the skin), washcloth and towel.
• Trim Pubic Hair:
  Always wash your hands before beginning. Trim hairs on the shaft and base of your penis, and any other pubic hair that might interfere with the adhesive on the catheter.
• Cleanse Your Penis:
  In order for the catheter adhesive to perform properly, the skin must be clean and very dry. Wash your penis with mild soap (does not contain artificial fragrance) and warm water. Be sure to allow the area to dry completely before proceeding.
• Application and Positioning:
  Place the rolled self-adhering catheter over the penile tip. Slowly and carefully unroll the catheter, leaving just enough space in the funnel end so the tip of your penis does not rub against the inside of the funnel. If uncircumcised, be sure to leave the foreskin in place over the head of the penis.
  
  
   
• Squeeze to Set:
  Smooth out any wrinkles in the Spirit Style 3 Catheter. Gently squeeze the catheter to properly seal it to the skin. Wear time may be significantly reduced if the adhesive is not properly sealed.
  Note: Too many wrinkles in the catheter may indicate that an inappropriate size has been selected. A smaller catheter may be more effective.
  
  
   
• Connect to Drainage Device:
  Strap the drainage bag to your thigh or calf, depending on your activities and your clothing. Connect one end of the tubing to the catheter and cut the tubing to a comfortable length. Connect the cut end to the leg bag. Always empty your leg bag before it becomes uncomfortably full and pulls on the catheter.
• Wear Time:
  Wear time will vary from user to user. For proper hygiene, it is recommended that a male external catheter be changed every 24 hours.
• Remove the Connections:
  Clamp the connecting tube closed before removing the leg bag. Release the bag straps and disconnect the tubing at the top of the bag.
• Remove the Catheter:
  Gently roll the external catheter forward and off the penis. To help loosen the adhesive prior to removal, apply a warm wet compress (such as a wet washcloth) around the catheter.
  
  

Precautions to take while using Rochester Hydrocolloid External Catheter

• Do not use if allergic reaction occurs.
• For good hygiene, change catheter daily.
• Use of a single device for longer periods than 24 hours may increase the risk of complications.

Contraindications:

• Do not use on irritated or compromised skin.

Spirit Style 2 Male Catheter Sheath Fitting Instructions