View product option

Responsive Respiratory EMS Oxygen Regulator - 25 LPM CGA 540

Q & A

Non Returnable
FSA approved
Size Chart

Responsive Respiratory EMS Oxygen Regulator - 25 LPM CGA 540 is intended for the administration of oxygen to patients who need to increase oxygen levels to improve their breathing conditions. In addition, some models may be used in emergency situations. In an emergency situation, one should be sure to contact a physician or EMS immediately. 25 LPM Regulator, CGA 540 with dual DISS demand valve and barb outlet. Oxygen Regulator is made of the lightweight aluminum outer sleeve with all brass inner core. Rated for use up to 3000 PSI and can be used on composite cylinders up to 3000 PSIG. Has high visibility gauge. The oxygen regulator meets FDA, CGA, ASTM Standards, including ignition testing.

How to set up Responsive Respiratory EMS Oxygen Regulator?

Inspect the cylinder following the instructions of the gas supplier. Be sure to purge the cylinder valve seat of debris
Inspect the regulator for oil or grease. If visible. DO NOT use the regulator
Gently thread the large nut on the regulator onto the connection on the cylinder valve
Tighten the nut with a wrench until snug
Attach the oxygen supply tubing to the outlet connection of the regulator

How to use EMS Oxygen Regulator?

Be sure the regulator is in the off position by rotating the knob counterclockwise to the 0 position
For safety be sure you are not directly in front of or behind the regulator when opening the cylinder valve
Slowly turn the cylinder valve on (counterclockwise), about one full turn
If a hissing sound comes, there is a leak in the system. Turn the cylinder off and turn the regulate on to relieve any built up pressure. Try tightening the regulator to the cylinder and opening the cylinder again. If this does not help, shut the system down again and contact a service representative
Adjust the flow rate setting by turning the knob clockwise until the desired setting shows through the window
If the cylinder pressure falls below 300 PSI, one should exchange the cylinder for a full one
Turn off the system, close the cylinder valve, wait for oxygen to flow out of the regulator, and turn the regulator to the 0 position
NEVER try to remove the regulator unless the cylinder is off and pressure has been relieved

Flow Ranges : .5, 1, 2, 4, 6, 8, 10, 12, 15, 20, 25 LPM

Cylinder Duration at designated flows Chart

Warranty

2 Year Manufacturers Warranty: Covers internal components only. External gauges, barbs, washers, knobs and Tee handles are not covered.

Product Videos

{{x.ShortDescription}} ...

Customer Reviews

Also Available

${{ x.OurPrice | currency: "" : 2}}