Precision Medical EasyVac Aspirator

Precision EasyVac Features

• Protective canister bracket which not only holds the canister but also protects the gauge and adjustment knob from accidents
• High performance 1/5 horsepower pump delivers 0 inHg to 26 inHg (0 mmHg to 660 mmHg)
• Velcro strap allows the power cord to be wrapped securely to make portability easier
• Extra strength premium suction feet attach the unit safely and securely to most surfaces, preventing spillage
• Safety is assured with the automatic resetting thermal limit switch which prevents the unit from overheating

Easyvac User Manual
Aspirator Suction Product Manual

Aspirator Vacuum Pump Parts Description

Also Available (separately):

• Precision Medical Suction Canister For Easy Go Vac Aspirator (Code: 502519-10)
  

How to use Aspirator Suction Machine?

1. Place Easy Vac Aspirator near electrical receptacle on a table, floor or other horizontal, smooth, hard surface. Allow a minimum of 4 in. (10 cm) clearance on all sides to ensure adequate air flow for cooling of Aspirator.
2. Press down on Aspirator until Suction Feet are secure.
3. Be sure the On/Off Switch is in the “Off” position.
4. Be sure the Inline Hydrophobic Filter is properly connected to the vacuum port on the Suction Canister lid. The Inline Hydrophobic Filter prevents liquid from entering the vacuum pump.
5. Plug the Aspirator into receptacle.
6. Turn the On/Off Switch to the “On” position.
7. Block the patient connection on the Suction Canister and adjust the Vacuum Control Knob to the desired vacuum.
   
   • To increase vacuum - Turn knob clockwise
   • To decrease vacuum - Turn knob counter-clockwise.
   Vacuum should be set as prescribed by Provider.
8. Connect one end of the Patient Suction Tubing to the port on the Canister marked Patient Tubing.
9. Connect the other end of the Patient Suction Tubing to the suction catheter and begin procedure as instructed by Provider.
10. When procedure is completed, press the On/Off Switch to the “off” position. Do not overfill the canister.
11. Remove the canister from its bracket and empty as instructed by your Provider.
12. Replace Suction Canister and reconnect all suctioning tubing.

How to Maintain and Clean Easy Vac Aspirator PM60?

Turn the Easy Vac Aspirator off and disconnect from any external power source before cleaning.
Inline Hydrophobic Filter -
This filter cannot be cleaned. If it becomes contaminated or clogged, it must be replaced 
To replace Inline Hydrophobic Filter:

• Disconnect filter assembly from Suction Canister and remove Suction Canister from the Aspirator 
• Remove filter assembly from the Aspirator
• Dispose of filter 
• Install new filter (Part 1690) and reconnect tubing and elbow 
• Tubing is single patient use only. DO NOT clean

How to Clean Aspirator Suction Unit Exterior Components?

• Disconnect the Aspirator from power source and other connections before cleaning 
• Use a cloth or sponge dampened with soap and water 
• Wipe dry with a clean cloth or paper towel 
• Store the Aspirator in a clean area free from grease, oil, and other sources of contamination