Optec Primo Classic TLSO Back Support
Optec Primo Classic TLSO Back Support

Optec Primo Classic TLSO Back Support

Brand/Manufacturer: OPTEC USA
Save
Authorized Retailer Badge

Optec Primo Classic TLSO (torso lumbosacral orthosis) Back Support is designed to contour the patient's body by providing an intimate fit with unsurpassed comfort. It provides maximum compression to unload intervertebral discs and restrict unwanted motion. The Primo front is fabricated from revolutionary spacer fabric and when compared to laminates has lower volumetric weight, is less bulky and will not delaminate. The Primo rigid back polymer shell design incorporates built-in reinforcement and a spinal relief opening.

Buy this product and earn 2.3 Reward Dollars.

  • ORDERING DETAILS
  • Model
  • Size
  • Total: $320
    Total: $229.99
Total: $320
Total: $229.99

Optec Primo Classic TLSO Back Support Features

  • Indicated for:
    - Burst Fx
    - Chronic back dain
    - Compression fracture
    - Degenerative, herniated or bulging disc
    - Kyphosis
    - Laminectomy
    - Osteoporosis
    - Paraplegia
    - Post-operative
    - Spinal stabilization
    - Spinal stenosis
    - Spondylolysis
    - Spondylolisthesis
  • Recommended for use on post-operative patients or for cases of severe pain
  • Combines a soft front with a rigid back
  • Note: Special care must be taken with insensate patients to avoid causing pinching along the mid-axillary line, especially in the waistline region

More On Optec Primo Classic TLSO Back Support

Primo TLSO with DLK (Dorsal Lumbar Kit) fitting instructions:
  • With only the left side of the back panel attached to the front panel and the Sternal Panel of the DLK attached to left side only, slip your arms through the loops of the DLK as if putting on a backpack. Your caregiver should have already adjusted the DLK to the appropriate height.
  • Position the brace with the lateral waist grooves at your waist and the back panel centered on your back either by using the log roll method, with or without assistance, or by placing the back panel on your back while standing.
  • Center the Back Plastic Panel on your back and position the waist grooves at your waist. Attach the bottom placement strap (the shorter section) to the front panel by pulling it forward and pressing the strap firmly onto the soft velcro on the front edge.
  • Using the arthritic thumb grips (D-rings), detach the bottom compression straps and pull straps simultaneously away from your body. Secure both compression straps to the center of the orthosis. Repeat for top compression straps.
  • Snap the loose side of the Sternal Panel into the other side of the buckle. Your caregiver should have already adjusted the straps of the Sternal Panel so that the straps of the DLK sit comfortably on your shoulders.
  • Pull the shoulder straps on the DLK simultaneously to the appropriate amount of tension, as originally directed by your caregiver. For best results, re-tighten all straps while laying on a flat surface with your knees bent and feet flat. Finally, ensure that orthosis fit is snug and does not cause any discomfort.

Care and general guidelines:
  • Patients are advised to purchase snug-fitting (a size smaller than the usual) undershirts to wear under the orthosis. For the duration of acute care, nursing must periodically remove the orthosis to check the patient’s skin.
  • Hand wash at 86 degree F with mild soap.
  • When drying, do not expose to direct heat (heater or sunlight); air dry.
  • Never iron or dry clean. If not rinsed well after washing, residual soap may cause skin irritation and product deterioration.
  • It is not uncommon for your body to change size under the spinal brace, because of the compression of the brace and because of a reduction in post-surgical swelling.
  • If you change enough in size that you can no longer adjust the straps enough to get good compression, see your practitioner for a follow-up visit to resize or replace your brace.
  • Your practitioner knows your medical status and is using the spinal brace as one part of your total care.
  • It is important to follow his or her instructions exactly, even if they differ from some of the preceding guidelines.

Specifications Of Optec Primo Classic TLSO Back Support

Size

Waist Measurement

Hip Measurement

Anterior Height (LSO LP)

Anterior Height (LSO)

Posterior Height
(With Liner)

Posterior Height (Polymer Panel)

X-Small

26" to 32"

31" to 37"

7-12"

9"

16-1/2"

14-1/2"

Small

30" to 36"

35" to 41"

7-12"

9"

16-1/2"

14-1/2"

Medium

34" to 40"

39" to 45"

7-12"

9"

16-1/2"

14-1/2"

Large

38" to 44"

43" to 49"

7-12"

9"

16-1/2"

14-1/2"

X-Large

42" to 48"

47" to 53"

7-12"

9"

16-1/2"

14-1/2"

2X-Large

46" to 52"

51" to 57"

7-12"

9"

16-1/2"

14-1/2"

3X-Large

50" to 56"

55" to 61"

7-12"

9"

16-1/2"

14-1/2"

Warranty

90 days warranty

Customer Reviews

Questions & Answers


 
 
Please enter your and your friends email address below.
Fields marked with * are compulsory
 
*
*
*
*

 
SubmitCancel
The selected product information has been successfully emailed to your friend.

Thank you for using www.healthproductsforyou.com

Close