Nestle Compat Enteral Feeding Pump
Nestle Compat Enteral Feeding Pump

Nestle Compat Enteral Feeding Pump

Brand/Manufacturer: NESTLE NUTRITION
Save

Nestle Compat Enteral Feeding Pump is versatile, lightweight and easy to use feeding pump, designed for the administration of enteral tube feeding formulas. The new molded bracket securely holds the administration set in place. The dual display window allows the caregiver to monitor infusion rate, volume delivered, and dose limit simultaneously. Compat Feeding Pump is accurate and easy to set up and adjust.

Item #DescPkgPrice 
199235 7.4"H x 9.5"W x 5.3"D Each $795.55 $529.99

Compat Enteral Feeding Pump

Key Features:

  • Ease of Use
  • Versatility: Rate adjustable in 1 mL/hr increments from 1–295; Dose adjustable in 5 mL increments from 0–9995
  • Lightweight and Portable: The internal battery will operate for 8 hours at 100 mL/hr
  • Ease of Maintenance: The fire resistant plastic case and sealed control panel prevent fluid leakage and allow cleaning with any mild soap
  • Easily Understood Alarms: Low Battery, Battery On, Dose Complete, and Occlusion/Empty for detecting empty container or occluded line
  • 2-1/2 Minute Hold Alarm
  • Low Occlusion Pressure: 15 p.s.i. occlusion allows for safe use with any enteral feeding tube
  • Built-in Pole Clamp
  • Total Volume Delivered Display
  • Adjustable Alarm Volume
  • Memory Retention of Infusion Rate, Dose Limit, Volume Delivered and Accumulated Volume even after unit is turned off
  • Settings are automatically recalled when the pump is turned back on
  • Serviceability: Self-diagnostic mode allows for complete circuitry check with the push of 2 buttons

Dose Limit:

  • Dose adjustable in 5ml increments from 0ml to 9995ml
  • Automatically stops after predetermined volume is delivered
  • 3 alarm options to signal dose complete
Click Here For User Manual

More On Compat Feeding Pump

Instructions For Use:

  1. Plug the power cord into a 120VAC., 60 Hz. three wire grounded outlet.
  2. Press ON—alarm will sound briefly. Remember, the pump has memory and will automatically recall the previous parameter settings.
  3. Check Infusion Rate. If change is desired, press INC or DEC to change rate setting.
  4. Check Dose Limit by pressing Dose Limit Set. If change is desired, press INC or DEC within the next 3 seconds to change setting limit. Zero Dose Limit implies no dose limit monitoring by pump.
  5. Press Total Reset to clear Total Volume, if desired.
  6. Insert drip chamber into drip chamber bracket.
  7. Open roller clamp on set. Expel air from tubing. Close clamp.
  8. Stretch silicone tubing around rotor. Insert pump adapter into bracket.
  9. Place tubing into tubing guide.
  10. Attach pump set to the feeding tube of patient.
  11. Open roller clamp on set.
  12. Press RUN/HOLD to start pump.
  13. “OFF” will turn off the pump at any time. (Infusion Rate, Dose Limit, Volume Delivered and Accumulated Volume are retained.)

Cautions:

  • Not for parenteral use
  • Intended exclusively for enteral tube feeding formulas
  • Silicone tubing that is not properly secured around the pumps rotor may result in a free flow situation
  • Always assure that the pump adapter is correctly seated into the bracket
  • This is particularly important when using water or liquid, as proper alarm function may not occur if the administration set is not secured properly

Specification

ParticularsSpecifications
MechanismRotary peristaltic
Infusion Rate1ml to 295ml/hr in 1ml increments
Accuracy±10% of selected flow rate
Occlusion PressureDoes not exceed 15 p.s.i.
BatterySealed lead acid Rechargeable
Automatically recharges when connected to an AC outlet Recharge time is 12 hours from complete discharge to full recharge
Operating time is 8 hours at 100ml/hr (Charge unit fully every 30 days)
Weight5.7lb
Power Requirement120V , 187mA, 60Hz
Operating Temperature10°Cto 40°C (50°Fto 104°F) 75% R.H. non-condensing
Storage Temperature0°Cto 50°C (32°Fto 122°F) 95% R.H. non-condensing

 

Customer Reviews

Questions & Answers


 
 
question image
were do u get operation instruction manual
christy - 2/5/2017 4:10:54 AM
facebooktwittergplus
answer image
Please find Instruction manual of Nestle Compat Enteral Feeding Pump on below link.
Customer Care - 2/6/2017 3:33:48 AM
question image
What tubing is required for a ready to hang bottle on a Compat feeding pump?
Vicki Bryan - 8/30/2016 3:24:32 PM
facebooktwittergplus
answer image
Thank you for contacting customer care service. 
Please refer below Operation Manual for Tubing Guide.
 http://www.nestle-nutrition.com/nirf/cm2/upload/89826D51-C0EA-473D-9450-098DE13F776C/CMPT-10262-0308_199235OperatingManual.pdf
Customer Care - 9/9/2016 2:01:03 AM
Please enter your and your friends email address below.
Fields marked with * are compulsory
 
*
*
*
*

 
SubmitCancel
The selected product information has been successfully emailed to your friend.

Thank you for using www.healthproductsforyou.com

Close