Medline Electric Stand Assist Patient Lift

How To Assemble Medline Patient Lift?

1. Engage the brakes. Remove the bolts from the bottom of the mast and base. Pull the mast to an upright position. Re-insert the bolts into the holes at bottom of the mast and tighten the nuts
2. Attach boom to top of mast. Re-insert the bolts into the holes at top of the mast and tighten the nuts. 
3. Attach the bottom actuator to the bracket on the mast and insert pin. Insert keeper ring through hole in pin to secure base of actuator. 
4. Attach the top of the actuator to the bracket on the boom and insert pin. Insert keeper ring through hole in pin to secure actuator to upper bracket. 
5. Unfold the square tubing at the footplate in a upright position. Install the kneepad at the top of the square tubing with bolt and nut and 2 sets of washers
   
   

• Do not attempt to transfer a resident without prior approval of the resident nurse or doctor. Also, do not transfer without having studied the instructions and practiced operating the lift several times
• The sling selected should be one that serves the needs of the resident
• Never operate the lift unless you have been properly trained on all procedures and safe handling methods
• Do not put anything (e.g. cushion, pad, etc.) between the resident and the sling. This may cause the resident to slide out of the sling and cause injury
• Avoid personal injury by making sure children or pets are away from the Medline MDS400SA or MDS600SA while it is inuse
• Avoid personal injury by making sure all extremities (such as fingers, arms, legs, or feet) are clear of the lift mechanismwhile it is in operation.
• Avoid personal injury by making sure the electrical connector is disconnected before conducting any electrical inspection

Medline Electric Patient Lift Specification

Warranty

Customer Reviews

Questions & Answers

Ask a Question

Enter your question below:

 

Security question 3+ 8 =   SubmitCancel

Enter your Answer below.

Security Question:3 + 8 =

	ItemQuestion ItemName - now
	Your question will show here once it will get approved.

	UserAnswer UserName - now Your Answer will show here once it will get approved.