Maddak Six Inches Contoured Tall-Ette Elevated Toilet Seat
Maddak Six Inches Contoured Tall-Ette Elevated Toilet Seat

Maddak Six Inches Contoured Tall-Ette Elevated Toilet Seat

Brand/Manufacturer: MADDAK, INC.
Save
Authorized Retailer Badge
  • HyGiene Products
  • Non Returnable

Maddak Six Inches Contoured Tall-Ette Elevated Toilet Seat has contoured surface which provides a more comfortable and supportive seat. Standard toilet seat come with a Slip-In Lok-In-El Bracket that provides a fast, convenient and safe way to secure the seat. Elongated toilet seats come with the Lok-In-El bolt-down bracket that holds the elevated seat securely on elongated toilet bowls, full inner ring contact with the bowl is not required.

Cannot be shipped Rush or Expedited delivery.

Item #DescPkgRewardPrice 
F725861000 Standard Each $0.54
$75.55
$53.99
F725831006 Elongated Each $0.57
$80.60
$56.99

Features

Note : This item is non-returnable due to hygiene reason

More Information

  • How to Use:
    - Place the Tall-ette Elevated Toilet Seat upside down on a table or bench with its two bracket holes visible
    - Hold the Lok-In-El Bracket with the two pegs lined up with the holes on the seat
    - The bolt-down bracket tongue should be facing away from the seat
    - Press the pegs into the holes until the bracket is in place
  • To Install on Toilet (F725831006)
    - Loosen the nuts on the toilet seat bracket that hold the toilet seat and lid to the bowl. Be sure to loosen them enough to slide the Lok-In-El bracket between the seat and the bowl
    - Lift the toilet seat to a raised position and pull up slightly - approximately 3/8"
    - Slide the Lok-In-El bracket tongue under the seat bracket so that the wide section fits between the toilet seat screws and the two narrow sections fit outside of the screws
    - Tighten the nuts on the screws to secure the seat and bracket. The Tall-ette  Elevated Toilet Seat should be in contact with the china bowl with the bottom flange fitting inside the rim of the toilet bowl. Before tightening the screws, move the seat forward as much as possible to make sure the seat sits firmly in the bowl
  • To Install on Toilet (F725861000)
    - Lift the toilet seat to a raised position
    - Hold the Tall-Ette Elevated Toilet Seat so that the Lok-In-El bracket tongue points at a downward angle and slide the Lok-In-El bracket under the hinge pin between the bolts that hold the toilet seat in place
    - As the tongue slides into place, the Tall-Ette Elevated Toilet Seat should come to rest directly on the china bowl with the bottom flange fitting inside the rim of the toilet bowl
    - Now sit on the Tall-Ette Elevated Toilet Seat. The weight of your body will tighten the Lok-In-El brackets peg joint if it had not previously been seated completely
  • Caution:
    Do not use these models without the Lok-In-El Bracket
    Do not remove the Lok-In-El Bracket
    Do not use the Tall-Ette Elevated Toilet Seat if it does not fit into the toilet bowl rim

Warranty

12 months parts and labor

Customer Reviews

Questions & Answers


 
 
Please enter your and your friends email address below.
Fields marked with * are compulsory
 
*
*
*
*

 
SubmitCancel
The selected product information has been successfully emailed to your friend.

Thank you for using www.healthproductsforyou.com

Close