Invacare Tracer EX2 16 Inches Wheelchair

Tracer EX2 Wheelchair Features

• Urethane rear tires mounted on "no flex" wheels offer superior performance
• Low-maintenance, dual-sealed precision bearings
• Heavy-duty inner liners keep seat and back from stretching
• Removable, full-length, padded arms for easy transfers
• Comes in silver vein color
• Meets RESNA standards for manual wheelchairs in product performance

Invacare EX2 User Manual
 

What to buy with Invacare Tracer Wheelchair?

• Invacare Tracer EX2 18" x 16" Frame With Permanent Arm Silver Vein Wheelchair

How to Use Invacare Tracer EX2?

Adjusting Footplate Height:

1. Remove the front rigging assembly.
2. Pull the cam lock lever up to the unlocked position.
3. Push in the release buttons and reposition the footplate assembly to the desired height.
4. Ensure that the release buttons fully protrude from holes on both sides of the front rigging support.
5. Rotate cam lock lever down to the locked position.
6. Repeat this procedure for the other footplate, if necessary.
7. Reinstall the swingaway front rigging assembly.

Adjusting Seat Depth:

1. Remove the existing seat upholstery from the wheelchair.
2. Remove the two plug buttons from the ends of the crossbraces that are towards the front of the wheelchair.
3. Install the two seat extension tubes into the ends on the crossbraces. Line up the rear mounting hole of the seat extension tube with the second mounting hole from the end of the crossbrace.
4. Install the two seat extension spacers onto the two seat extension tubes.
5. Install the new seat upholstery onto the wheelchair. Make sure to line up the mounting holes in the seat extension tubes and seat extension spacers with the new seat upholstery.
6. Install plug buttons into the ends of the seat extension spacers.

Adjusting the Seat Width:

1. Remove the existing back and seat upholstery from the wheelchair.
2. Remove the four button screws and locknuts that secure the two pivot links to the wheelchair frame and crossbraces.
3. Remove the two button screws, lock nuts and crossbrace saddle that secures the bottom of the crossbrace to the wheelchair frame. Repeat for other crossbrace.
4. Remove the hex screw, coved washers, washers and lock nut that secure the two crossbraces together.
5. Assemble the two new crossbraces together with the existing hex screw, coved washers, washers and lock nut. Securely tighten.
6. Determine the correct pivot link and mounting hole to use with the desired seat width.
7. Secure the pivot links to the crossbraces and wheelchair frame with the four button screws and locknuts. Securely tighten.
8. Reinstall the two button screws, lock nuts and crossbrace saddle that secures the bottom of the new crossbrace to the wheelchair frame. Repeat for opposite crossbrace. Securely tighten.
9. Install the new back and seat upholstery onto the wheelchair