Invacare Platinum 10 Stationary Oxygen Concentrator

Invacare Platinum 10 Liter Oxygen Concentrator Features

• Invacare Platinum 10 Stationary Oxygen Concentrator features Self diagnostic electronics that minimize troubleshooting time
• Battery-free power loss alarm, Invacare Sieve-GARD Monitor protects sievefrom degradation, compressor 35 psipressure-relief valve and low flow alarm
• User friendly design with easy to see control panel, humidifier bottle holder and filter access
• HomeFill system compatibility allows patients with flow rates up to 5LPM to enjoy life experiences with small, refillable cylinders
• Reliable concentrator provides unlimited, worry-free oxygen supply
• It provides Patient-accessible reset button which helps minimize emergency service calls
• Easy access to service by removing only four cabinet screws, a top handle and a side-access door for both the inlet filter and diagnostics
• Delivers the reliability, performance and value advantage
• Pressure-based system is superior to timing-based systems
• Self diagnostic electronics minimize troubleshooting time
• All Platinum 10 stationary concentrators include a HomeFill system port for inventory flexibility
• Patient-accessible reset button helps minimize emergency service calls
• User friendly design with easy to see control panel, humidifier bottle holder and filter access
• Reliable concentrator provides unlimited, worry-free oxygen supply

Compatible Accessories for Invacare platinum 10

• Invacare HomeFill Ready Rack for Platinum Oxygen Concentrators (Code IOH260)
• Invacare HomeFill Ambulatory Package (Code IOH200PC)

How to Operate Invacare Platinum 10?

• You may select a room in your house where using your oxygen concentrator would be most convenient. Your concentrator can be easily rolled from room to room on its casters.

• Plug in power cord to an electrical outlet.

1. Fill humidifier with distilled water to the level indicated by the manufacturer.
2. Place the humidifier bottle in the humidifier compartment.
3. Remove the filter access door located on the side of the concentrator. Insert a flathead screwdriver in the plate groove on the top edge of the filter access door and gently pry the filter access door open
4. The humidifier adapter is next to the inlet filter. Pull up and remove the humidifier bottle adapter.
5. Attach it to the humidifier by turning the wing nut on the humidifier bottle counterclockwise until it is securely fastened.
6. Attach oxygen tubing from the humidifier bottle to oxygen outlet connector on the oxygen concentrator.
7. Attach the cannula/patient supply tubing to the humidifier bottle outlet.
8. After assembly, ensure that oxygen is flowing through the cannula.

• Press power switch to on position. All the panel lights and the audible alarm will come on for one second, indicating that the unit is functioning properly. After one second, only the GREEN system ok/power light will stay on.

1. Turn the flowrate knob to the setting prescribed by your physician or therapist.
2. If the flowrate on the flowmeter ever falls below 0.5 L/min. for Platinum 5 (1 L/min. for Platinum 10) for more than about one minute, the LOW FLOW alarm will be triggered. This is a rapid beeping of the audible alarm. Check your tubing or accessories for blocked or kinked tubing or a defective humidifier bottle. After rated flow is restored, more than 0.5 L/min. for Platinum 5 (1 L/min. for Platinum 10), the LOW FLOW audible alarm will go off.

• This feature monitors the purity of oxygen generated by the oxygen concentrator. If purity falls below factory preset standards, indicator lights on the control panel will illuminate