Harmar Vehicle Wiring Harness
Harmar Vehicle Wiring Harness

Harmar Vehicle Wiring Harness

Brand/Manufacturer: HARMAR MOBILITY
Save
Authorized Retailer Badge

Harmar Vehicle Wiring Harness is recommended if using a Harmar Electric Mobility Carrier on more than one vehicle. It is approximately 23 feet in length and accommodates most vehicles. Harmar Vehicle Wiring Harness is powered by the supplied electrical harness. Wiring harness has full-length leads that attach directly to the battery.

Item #DescPkgRewardPrice 
H28010 Length: 23ft Each $3.80
$96.99
$75.99

How to wire vehicle using Harmar Wiring Harness?

  • Begin routing the wiring harness at the vehicle battery 
  • Attach the black wire to the negative terminal on the battery 
  • Do not attach the red wire until the end 
  • Run the wiring harness under or when possible through the vehicle, back to the rear cargo area/trunk 
  • Through the vehicle is best, gaining entry into the vehicle through the firewall 
  • If wiring harness is under the vehicle, a hole will most likely need to be drilled to get the wire into the rear cargo area/trunk 
  • Always locate the wiring where it cannot be snagged by road debris and away from the gas tank 
  • If the harness is too long for the vehicle, coil the excess wire and secure it to the vehicle frame with supplied tie wraps 
  • Once the harness is run into the vehicle, remove pins protective tubing Inspect the pins retaining flanges as it may have become deformed while running them through the vehicle 
  • These are critical to secure the pins inside the end connector 
  • Adjust as needed 
  • Flip open end connectors hinged retainer

Customer Reviews

Questions & Answers


 
 

Enter your Answer below.

Security Question: + =
question image
ItemQuestion
ItemName - now

Your question will show here once it will get approved.
answer image
UserAnswer
UserName - now
Your Answer will show here once it will get approved.
question image
Does this wiring harness work for all hamnar scooter lift or do I need to get model or seriel number off my lift
Dana Holis8+5=13 - 7/24/2017 4:18:35 PM
facebooktwitter
answer image
Harmar Vehicle Wiring Harness is specifically designed for almost all Harmar electric mobility lifts and is intended while using the lift on more than one vehicle.This harness accommodates most vehicle.
Customer Care - 7/26/2017 8:50:24 AM
question image
What type plug is on this harness?
Janice Horton - 6/25/2017 7:37:28 AM
facebooktwitter
answer image
Attached to the wire is a Male + Female plug that goes to the back of the Harmar Vehicle/Lift.
Customer Care - 7/4/2017 8:54:12 AM
Please enter your and your friends email address below.
Fields marked with * are compulsory
 
*
*
*
*

 
SubmitCancel
The selected product information has been successfully emailed to your friend.

Thank you for using www.healthproductsforyou.com

Close