EWheels EW-36 Electric Mobility Scooter

What to buy with EWheels Scooter

• PVI Portable Multifold Ramp

How to use EW-36 Mobility Scooter?

How to assemble and setup EW36 Electric Scooter?

1. Remove your EW-36 from its shipping carton. EW-36 weighs about 150 lbs, so get help and use care. Cutaway any residual packing materials with a knife or scissors.
2. Attach the Rear View Mirrors to the mounting holes. A wrench can be used to tighten the lock nuts at the base of each mirror.
3. Check if the brakes are properly adjusted. The brake handles should stop short of touching the handgrip when fully engaged. The rear brake cable can be adjusted in two places:
   • At the cable end bracket, just before the lever, with 8 and 10 mm wrench adjustments.
   • At the end of the lever, with a 10 mm nut fastener. The front brake is adjusted at the end of the cable, at the saddle nut.
4. Circuit Breaker. Using the ignition key, open the rear storage compartment located under the seat. Locate the circuit breaker and switch it from off to on.
5. Your EW-36 has been in transit and storage. You must charge the batteries before riding it. Charge the battery by plugging the charger into the EW-36 Charger Ports.

EW 36 Mobility Scooter Routine Operation

• Pre-Ride Check -
  1. Be sure the tires have enough air. A low tire pressure risk rim pinching (tube failure) and lowers your range (distance per charge).
  2. Be sure the battery is fully charged.
  3. Be very careful not to twist the throttle and engage the hand brake at the same time. If this occurs, excessive power will occur and this will cause the scooter to leap forward. Low state-of-charge will reduce range and can damage the battery.
  4. Verify the proper adjustment and function of the brakes.
  5. Make sure the EW-36 is in good mechanical order. Visually inspect and hand-check the vehicle, and snug any loose bolts, screws, or other fasteners.
  6. With the EW-36 visually inspected, turn the key switch and apply the throttle, to verify the motor’s smooth operation. Apply the brake to stop the motor. Verify that the throttle is inoperative when either brake is applied.
• Steps to Startup -
  1. Adjust the Rear View Mirrors so that you can see clearly behind you.
  2. Adjust the speed control knob! Adjust to slow for the initial ride until you feel comfortable.
  3. Insert the key into the key switch and turn the key from OFF to ON.
  4. The EW-36 has an onboard Voltmeter, indicating the Battery’s approximate state-of-charge. It is normal for this reading to “sag” somewhat during acceleration. Excessive Voltage “sag” is a sign of a depleted or damaged battery. When a battery is exhausted, if you force it to supply energy, it will dramatically damage the battery. At this time, the-low voltage protector will shut off the power automatically, protecting the battery from further damage.
  5. Hold onto the handlebars with both hands. Assume a well-balanced position. Your right hand will control the accelerator. Twist the accelerator slowly to avoid a sudden rush of speed forward. The speed of the bike will increase as you twist the accelerator more. Release the accelerator and apply the brakes to stop your bike. You will control the speed of the bike by using both the accelerator and the brakes. When the brake handle is squeezed, it cuts power to the accelerator.
  6. Give the EW-36 some acceleration and speed by first applying the throttle gently. Try not to brake and accelerate needlessly.
  7. Return the key to the OFF position and take out the key after riding, to secure your property and to save battery power.

Ewheels EW 36 Battery Maintenance

• Must charge completely prior to initial use
• Charge immediately after each use
• Charge before storage. You must charge every 30 days if not in use
• Charge the unit for 6-8 hours or until the light on the charger turns red and green
• Do not allow this unit to deep discharge the battery
• For safety purposes, do not charge for over 8 hours
• Turn the unit off when not in use

EW 36 Electric Mobility Scooter safety information

• Persons without excellent vision, balance, coordination, reflex, muscle and bone strength and good decision-making capabilities should not use this product
• Minors without adult supervision should not use this product
• Persons unwilling or unable to take responsibility for their own actions should not use this product
• The user of this product assumes ALL risks associated with its use. To minimize these RISKS, the user must wear safety helmet, goggles, gloves, elbow and knee pads and appropriate footwear
• This product is ELECTRIC. DO NOT ride this product in wet conditions, puddles or rainy weather
• The recommended minimum age for riding this scooter is 16 years old
• To avoid damage to the motor and footplate, do not overload the scooter
• Never ride with more than one person
• To avoid the risk of a short circuit in the electrical parts, do not use your electric scooter in the rain and never spray or wash off your scooter with water
• Do not place the battery near fire or heat
• To avoid damage to the battery, do not use the charger if it has been damaged in any way
• Keep hands, face, feet and hair away from all moving parts
• Do not touch the motor or wheels while they are rotating
• Brakes are designed to control speed as well as stop the scooter. Practice braking for proper slowing down and smooth stops
• Use only quality replacement parts as recommended by the manufacturer

EW-36 Electric Mobility Scooter Owners Manual